ROD 1686733 - Caterpillar

Specification
Table 1
"Machine Drift on a Slope - Check"
Drift mm (inch)
New Service Limit Actual
0 0 Introduction
Measuring the amount of drift of the machine on a slope will determine if there is a need to check the travel brake.Note: The machine configuration that is used during this test can affect the results of this test. Refer to Testing and Adjusting, "Operational Checks" for the machine configurations that were used for this test.Note: The relief valve pressure settings must be set to the relief valve pressure specification before performing this operational check. Refer to Testing and Adjusting, "Specifications".Required Tools
Table 2
Description Qty
Stopwatch 1
Scale 150 mm (6 inch) 1 Test Procedure
Illustration 1 g00297342
Place the machine on a slope of 12 degrees. The surface of the slope must be hard and smooth.
Position the implements, as shown. Refer to Illustration 1.
The bucket should be empty.
Illustration 2 g00297498
To indicate the relative position of the machine to the slope, put a mark on both the track and the track roller frame. Refer to Illustration 2.
Stop the engine.
Measure the machine movement on the slope after 3 minutes.