ROD AS 1733349 - Caterpillar

40. Install Duo-Cone seal (36) in the motor casing with Tool (G).
Do Not scratch or damage the Duo-Cone seals in the main housing or the motor housing during the assembly of these two components. After the installation of the main housing on the motor housing, there will be a small gap between the components. The gap is caused by the Duo-Cone seals and will be eliminated during the installation of gear (34).
41. Fasten Tooling (E) and a hoist to main housing (31). Put the main housing and final drive sprocket in position on the motor housing. Do Not scratch or damage the Duo-Cone seals in either component during the installation. 42. Apply 5P-3931 Anti-Seize Compound on the four pins in gear (34).43. Put shim pack (35) determined in Step 37a through 37g and gear (34) in the correct position on the motor housing. If two shims were required, put the thinner shim in contact with the gear (34). Make sure all of the holes in the components are in alignment with each other.44. Apply 9S-3263 Thread Lock on the threads of 16 socket head bolts (33). Install the socket head bolts to hold gear (34) in place. Tighten the bolts evenly and in diagonally opposite pairs to a torque of 900 100 N m (660 75 lb ft). 45. Install O-ring seal (32) in main housing (31). 46. Thoroughly clean the mating surface of main housing (31) that makes contact with ring gear (30). Apply a bead of 1U-8846 Gasket Maker on the mating surface of ring gear (30). Fasten lifting slings and a hoist to ring gear (30). Put the ring gear in position on the main housing. Make sure the alignment mark on the main housing and the ring gear line up with each other. It may be necessary to use a soft faced hammer to seat the ring gear on the main housing. 47. Assemble carrier assembly (24).48. Put clean SAE 30 oil on bearings (29). Install two bearings (29) in planetary gear (28).49. Install a thrust washer (27) on each side of the planetary gear. Install the planetary gear and the thrust washers in carrier (24). Make sure identification grooves "N" are facing in the correct direction.50. Install planetary shaft (26) in carrier (24) and through planetary gear (28). Make sure the spring pin hole in the planetary shaft is in alignment with the spring pin hole in the carrier.51. Install spring pin (25) in the carrier and into the planetary shaft. Install the spring pin until it is even with the outside surface of the carrier and with the split in the spring pin oriented horizontal to the carrier either to the left or right. 52. To prevent the spring pin from falling out, make a stake mark on each side of the spring pin hole in the carrier. Each stake mark should be approximately 1.5 mm (.06 in) from the outside diameter of the spring pin hole.53. Install the