ROD 1V8914 - Caterpillar

OFF - Press the lower part of the switch (99) in order to turn off the front window wiper.Control for the Rear Window Wiper (100)
The control for the rear window wiper is a three-position switch.
FAST - Push the upper portion of the switch (100) in order to select the HIGH speed for the rear window wiper.
SLOW - Move the switch (100) to the middle position in order to select the SLOW speed for the rear window wiper.
OFF - Press the lower part of the switch (100) in order to turn off the rear window wiper.Engine Start Switch
Engine Start Switch
Note: When starting the machine it is recommended that the engine start switch be turned to the ON position. The operator should observe the display and start the engine after the display has indicated RUN. Failure to follow this sequence could generate faults in the machine control during boot up of the machine control. Do not operate the machine when there is a display fault on the operator control panel.The engine start switch is a three-position keyed switch. The START position (103) is a momentary position.
Illustration 13 g02009473When you turn the engine start switch to the ON position (102), electrical power is supplied to the systems in the operator compartment.
OFF (101) - When you insert the engine start switch key and when you remove the engine start switch key, the engine start switch must be in the OFF position (101). To disconnect the power to the electrical circuits in the operator station, turn the engine start switch to the OFF position (101). Also, turn the engine start switch to the OFF position (101) in order to stop the engine.
ON (102) - To activate the electrical circuits in the operator station, turn the engine start switch key clockwise to the ON position (102).
START (103) - To start the engine, turn the engine start switch key clockwise to the START position (103). When the engine start switch key is released, the engine start switch key will return to the ON position (102).Note: If the engine fails to start, return the engine start switch key to the OFF position (100). This must be done before you attempt to start the engine again.Circuit Breaker Controls
Illustration 14 g02009474
The circuit breaker panel is located behind the access ladder on the left side of the machine. Unlock the cover of the circuit breaker box in order to access the control panel.
Rotor Service Switch (104)
The rotor service switch (104) is a two-position switch. The switch is located on the left side of the circuit breaker panel. Note: When the rotor service switch is engaged, the rotor service indicator (47) will illuminate on the display screen.Note: In order to prevent activation of the rotor during service, move the switch to the SERVICE position and lock the cover. Do not allow anyone to unlock the cover during service. Do not move the switch to the OPERATE position until all personnel, tools and debris are a safe distance from the rotor. Proper care