ROD AS 2159108 - Caterpillar

Download the current data for the truck. Refer to Step 6 through Step 9.
Illustration 65 g01799214
Select the "Brake 777".
In the "Brake System" folder, install the "Brake Oil Temperature Additional Monitoring System".Note: If the front brakes are oil cooled brakes, the "Oil Cooled Front Brake Installation Status" should display an "Installed" value. If the front brakes are not oil cooled brakes, the "Oil Cooled Front Brake Installation Status" should display a "Not Installed" value.
Illustration 66 g01799253
Select the "Chassis 777".
In the "Transmission Configuration" folder, install the "Coolant Level Sensor". Also, install the "Ambient Air Temperature Sensor".
Illustration 67 g01799257
In the "VIMS Main 777" folder, select "Tire Analysis System" and change the status from "Not Installed" to "Installed". Refer to Table 14 for additional changes that need to be made within the "Tire Analysis System".
Table 14
"Machine Weight Speed Averaging Duration"     Recommended rolling database time is 4 hours    
"Empty Machine Weight"     Information that is gathered during a payload calibration    
"Empty Machine Rear Axle Weight Distribution"     Information that is gathered during a payload calibration    
"Loaded Machine Rear Axle Weight Distribution"     Information that is gathered during a payload calibration    
"Machine Speed Limit Activation Front Tires Weight-Speed Threshold"     TKPH/TMPH trigger value. Consult the tire manufacturer for the specific TKPH value for the tires that are used on the machine    
"Machine Speed Limit Deactivation Front Tires Weight-Speed Threshold"     Recommended to be 100 less than the TKPH/TMPH trigger value    
"Machine Speed Limit Activation Rear Tires Weight-Speed Threshold"     TKPH/TMPH trigger value. Consult the tire manufacturer for the specific TKPH value for the tires that are used on the machine    
"Machine Speed Limit Deactivation Rear Tires Weight-Speed Threshold"     Recommended to be 100 less than the TKPH/TMPH trigger value    
"Machine Speed Limit"     Consult the tire manufacturer for the specific speed limit that is required to allow the tires to cool off during operation. This limit may be specific to the site    For additional information, refer to Special Instruction, REHS2662, "VIMS® TKPH/TMPH Monitoring".Flash the VIMS Software
Only perform the following steps if your machine has the 316-1238 Monitor Software Gp .
The VIMS software that has been updated on the 777F will require a factory password in order to turn on the system after flashing the software.
Illustration 68 g01799317
Diagnostic connector
Connect a laptop computer to the Caterpillar Diagnostic Connector (1) on the fuse panel behind the operator seat.Note: Use a 139-4166 Data Link Cable As , 171-4400 Communication Adapter Gp , NEXG4523 Service Program Module, and a 7X-1425 Data Link Cable As in order to connect the laptop computer.
In Cat ET, select the "Configuration" screen for the VIMS ECM.
Illustration 69 g01799257
Select the "Data Acquisition System Installation Status".
Turn the "Data Acquisition System Installation Status" to "Uninstalled".Note: A window will open that asks the operator for a factory password in order for the operator to disable the system.
Type the information from that window into the factory password system.Note: The factory password system will then generate a factory password.
Type the factory password that