ROD-END 2C1367 2C2474 - Caterpillar

1. Park the machine on level ground, set park brake, turn machine off, and tag machine for maintenance.2. Locate the 118-1499 outrigger control valve sections (3)(4) on the 129-6209 Directional Control Valve. See Illustration 1. The same modification should be performed for each solenoid controlling an outrigger going in the same direction. (5) (6) or (7) (8) should be shimmed the same. 3. Remove Nut, O-Ring, and Coil from the end of the outrigger valve section to be adjusted.4. Remove the tube from the valve by unscrewing the clamp flange.5. Remove the tube internals by pulling on the exposed spring bushing. The tube internals are retained by the o-ring.6. Remove the "C" Clip (9) and lift off the spring bushing (10), spring (11), and Pole (12). See Illustration 2.7. Add two 114-3364 Sealing Washers (1) to begin. Place the shims on top of the existing "anti-residual washer" (13). See Illustration 2.8. Check operation of the outriggers. See Operation & Maintenance Manual. If the outriggers move at a speed that is satisfactory then put machine back into service.
Illustration 1.129-6209 Directional Control Valve
Illustration 2.Tube.COPYRIGHT 1998 CATERPILLAR ALL RIGHTS RESERVED