ROD A 2H0083 - Caterpillar

Installation Procedure
Illustration 1 g01029593
Slide parking brake (5) onto brake disc (8) and install bolts (9). Do not tighten bolts (9) at this time.
Use the following procedure to adjust the parking brake:
Illustration 2 g01029632
Illustration 3 g01029633
Use a suitable feeler gauge to measure the distance between locknuts (10) and sleeves (11). If necessary, adjust locknuts (10) in order to set the gap to 0.6350 0.3810 mm (0.02500 0.01500 inch) before tightening bolts (9) to a torque of 150 N m (110 lb ft).
Illustration 4 g00951541
Loosen nut (13). Turn nut (12) in a clockwise direction. This action will apply the parking brake. Tighten nut (13) to a torque of 11 2 N m (100 20 lb in).
When the correct torque is achieved, turn nut (12) in a counterclockwise direction by 300 degrees 60 degrees. This action will release the parking brake and the parking brake lever will be set correctly.
Tighten nut (13) against nut (12). Tighten nut (12) to a torque of 68 6 N m (50 5 lb ft).
Illustration 5 g01029592
Position bracket (3) onto parking brake (5) and install bolts (4). Align cable (1) with lever (6) and install pin (7) and clip (2) .
Adjust the parking brake. Refer to Systems Operation, Testing and Adjusting, "Parking Brake Control - Check and Adjust.".