ROD AS 3056711 - Caterpillar

Illustration 5 g01223800
Attach a suitable lifting device and Tooling (B) to Tooling (C). Attach Tooling (C) to pin assembly (7). The weight of Tooling (C) is approximately 165 kg (365 lb).
Remove bolt (6). Use Tooling (C) to remove pin assembly (7). The combined weight of Tooling (C) and pin assembly (7) is approximately 196 kg (435 lb).Note: Reposition the suitable lifting device as pin assembly (7) is removed.
Remove O-ring seals (5) (not shown).
Use the machine hydraulics to raise the stick from bucket (1).
Illustration 6 g01202447
Remove bolts (11), plate (10), shims (9), and flange (8) from bucket (1).Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
D 9U-6225 Pin Driver Cap 1
E 4C-9485 Pin Driver Cap 1
F 452-6006 Grease Cartridge 1
Illustration 7 g01203298
Apply Tooling (F) to the outside machined surface of flange (8) and the bore for flange (8). Install flange (8) to bucket (1).Note: Ensure the alignment of pin in flange (8) is positioned between two bolt holes.
Illustration 8 g01203184
Position O-ring seals (5) onto the flanges of bucket (1).
Use the machine hydraulics to position the stick into bucket (1).
Illustration 9 g01223803
Install Tooling (D) to pin assembly (7). Apply Tooling (F) to pin assembly (7).
Attach a suitable lifting device to pin assembly (7). The weight of pin assembly (7) is approximately 34 kg (75 lb). Install pin assembly (7).
Remove Tooling (D) from pin assembly (7).
Illustration 10 g01203252
Install bolt (6).
Illustration 11 g01203254
Illustration 12 g01203317
Align the locating hole in plate (10) with the locating pin in flange (8). Position shims (9) and plate (10). Install bolts (11) and tighten bolts (11) evenly.
Move the bucket to the side until the bucket contacts the stick. Measure the clearance between the bucket and the stick at flange (8). Record this dimension as Dimension (X). Remove bolts (11) and plate (10). Add or remove shims (9) until Dimension (X) is between 0.5 mm (0.02 inch) and 1.0 mm (0.04 inch). Install flange (8) and bolts (11). Tighten bolts (11) evenly.
Illustration 13 g01202427
Position O-ring seals (5) from the flanges of bucket (1) into the pin joint.
Illustration 14 g01223804
Install Tooling (E) to pin assembly (4). Apply Tooling (F) to pin assembly (4). Attach a suitable lifting device to pin assembly (4). The weight of pin assembly (4) is approximately 34 kg (75 lb). Position the bucket linkage to install pin assembly (4). Install pin assembly (4). Remove Tooling (E) from pin assembly (4).
Illustration 15 g01203363
Install bolt (3) to pin assembly (4).
Illustration 16 g01202290
Position O-ring seals (2) from the flanges of bucket (1) into the pin joint.