ROD AS 3405943 - Caterpillar

Differential Lock Control (18)
Refer to Operation and Maintenance Manual, "Differential Lock Control" for more information.Service Brake Control (19)
Refer to Operation and Maintenance Manual, "Service Brake Control" for more information.Accelerator Control (20)
Increasing Speed - Depress the pedal in order to increase the travel speed.Decreasing Speed - Release the pedal in order to decrease the travel speed.Transmission Control (21)
Refer to Operation and Maintenance Manual, "Transmission Control" for more information.Parking Brake Control (22)
Refer to Operation and Maintenance Manual, "Parking Brake Control" for more information.Hoist Control (23)
Refer to Operation and Maintenance Manual, "Hoist Control" for more information.Work Area Visual System (WAVS) (If Equipped)
WAVS Operation
WAVS is a closed circuit video monitoring system. WAVS consists of a 178 mm (7 inch) LCD display and a camera. The display is mounted in the machine cab. The camera is mounted on the frame at the rear of the machine.Power is supplied to the system when the operator turns the engine start switch to the ON position. The power On/Off button that is on the display is disabled. The camera lens and the display screen will require periodic cleaning. Cleaning instructions for the camera lens and the display are described in the Maintenance section.Automatic Mode
The single camera system is only available with the automatic mode. The single camera system can be placed in "Standby".Note: If the single camera system can be placed in manual mode, notify service personnel.WAVS will automatically display the camera view which is based on current machine operation and the WAVS configuration. For example, WAVS may be configured to display the view from a rear camera when the operator selects reverse gear.Camera
Illustration 2 g01223051
WAVS camera
The orientation of the camera is set during installation. The rear camera is set to provide a reverse image that is similar to a mirror view.After installation, there should be no need to make any physical adjustments to any of the cameras under normal operating conditions. WAVS uses a fixed-focused camera that has been installed at the factory, a Caterpillar dealer, or a qualified technician.Display
Keypad
Illustration 3 g01291176
(A) Camera Selection Button (multiple camera only)
(B) Automatic Brightness
(C) Standby Function
(D) Contrast Button
(E) Brightness Button
(F) Decrease Adjustment Button
(G) Increase Adjustment Button
(H) Power Button (disabled)
(I) Camera Select LEDs (multiple camera only)
(J) Button Status LEDs
(K) Light Sensor Adjustment
The following selections for the WAVS display can be changed by the operator.
Table 1
Display Button Operation for single camera system
Operation Procedure Notes
Brightness Adjustment Press button (E) in order to enable the "Brightness Adjustment", then press either button (F) or (G) in order to adjust the brightness. Press any other display button in order to exit brightness adjustment mode.
Contrast Adjustment Press button (D) in order to enable the Contrast Adjustment, then press either button (6) or (7) in order to adjust the contrast level. Press any other display button in order to exit the contrast adjustment mode.
Automatic Brightness ON/OFF Press button (B) in order to turn the automatic brightness ON/OFF. When WAVS is placed in the "Automatic Brightness" mode, the display will illuminate or dim automatically as the ambient light increases