ROD AS-HYDRAULIC CYLINDER 3612830 - Caterpillar

Illustration 1 g03355599
Rear view of engineTypical example
Illustration 2 g03355600
Typical example
Illustration 3 g03355601
Typical example
Table 1
Specification for 369-9363 Rear Gear Gp and 369-9365 Rear Gear Gp    
Item     Qty     Part     Specification Description    
1     2     369-9356 Idler Gear As     After installation, bore of 125-9751 Bushing in the idler gear assembly is 81.060 0.010 mm (3.1913 0.0004 inch).
Installation depth of the bushing is
1.00 0.25 mm (0.049 0.010 inch).    
2     4     8M-2530 Bolt     Torque to
140 10 N m (103 7 lb ft).    
3     2     368-6914 Camshaft Drive Gear     Before assembly, clean the taper of the camshaft and the tapered bore of the camshaft drive gear with lint free cloth saturated with cleaning solvent to remove excess oil. Clean with alcohol wipe.
Refer to Disassembly and Assembly for the installation procedure for the left and right camshaft drive gear .    
4     2     9X-8887 Bolt     Use the following procedure to tighten the bolt for the camshaft drive gears:
1. Tighten the bolt for the camshaft drive gear to
360 40 N m (266 30 lb ft).
2. Mark a vertical line on the head of the bolt for the camshaft drive gear. Refer to Illustration 2.
3. Place a driver against the retaining plate of the camshaft drive gear. Strike the driver solidly with a hammer 3 to 4 times.
4. Again, tighten the bolt for the camshaft drive gear to
360 40 N m (266 30 lb ft).
5. Repeat Step 3 and Step 4 until the mark on the bolt turns a minimum of 90 degrees. Refer to Illustration 3.    
5     4     1B-4367 Bolt     Torque to
240 20 N m (177 15 lb ft).    
6     1     369-9357 Idler Gear As     After installation, bore of 101-1372 Bushing in the gear assembly is
75.060 0.010 mm (2.9551 0.0004 inch).
Installation depth of the bushing is
1.5 0.5 mm (0.06 0.02 inch).    
7     2     101-1367 Idler Shaft     Diameter is
81.000 0.010 mm (3.1890 0.0004 inch).    
8     1     101-1365 Thrust Plate     Thickness of the new thrust plate is
6.35 0.25 mm (0.250 0.010 inch).    
9     2     8S-2331 Bolt     Torque to
240 20 N m (177 15 lb ft).    
10     2     101-1368 Thrust Washer     Thickness of the new thrust washer is
1.90 0.10 mm (0.075 0.004 inch).    
11     1     101-1366 Gear Shaft     Diameter is
74.990 0.010 mm (2.9524 0.0004 inch).