ROD & BEARING AS-CYLINDER 3686819 - Caterpillar

Illustration 1 g01410593
Right Steering Pump Solenoid connectionsThis diagnostic code is associated with the Right Steering Pump Solenoid. The Machine ECM will use a PWM output driver in order to control the solenoid. The FMI 06 means that the Machine ECM has determined that the current of the solenoid circuit is above normal.Conditions that could causes this diagnostic code to be activated are:
The energize circuit of the solenoid is shorted to a ground source.
The solenoid has failed.
The ECM has failed. This is unlikely. This procedure should not require entry into any enclosures that contain hazardous voltage components and should not require any hazardous voltage connections to be disconnected.When an area that contains hazardous voltage components must be entered for a service procedure, the "Safe Shutdown Procedure for Electric Drive Tractors" procedure must be performed before any enclosures that contain hazardous voltage components are opened or before any hazardous voltage connectors are disconnected. Refer to the Troubleshooting, "Electrical Maintenance Guidelines" section of this manual. Perform the "Safe Shutdown Procedure for Electric Drive Tractors" procedure before any of the hazardous voltage areas are opened or before hazardous voltage connectors are disconnected.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Note: The resistance of a good solenoid coil should be 4.75 0.3 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. DO NOT START THE ENGINE.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:The active CID 0726 FMI 06 diagnostic code changes to a CID 0726 FMI 05 diagnostic code when the solenoid is disconnected.Results:
YES - The active CID 0726 FMI 06 diagnostic code changes to a CID 0726 FMI 05 diagnostic code when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - The CID 0726 FMI 06 remains active when the solenoid is disconnected. The solenoid is not causing the problem. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUNDThe solenoid remains disconnected from the machine harness.
Turn the key start switch and the disconnect switch to the OFF position. DO NOT START THE ENGINE.
Disconnect the machine harness connectors J1 and J2 from the Machine ECM.
At the machine harness ECM connectors, measure the resistance from the contact J1-68 (wire F789-YL) to frame ground. Measure the resistance from the contact J1-68 (wire F789-YL) to all of the other J1 and J2 contacts that are used in the Machine ECM connectors.Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - One or more of the resistance measurements is less than