ROD AS 3736364 - Caterpillar

Illustration 23 g00344118
Install four bolts (36) in head (3). The torque for the bolts is 1000 100 N m (740 75 lb ft).
Illustration 24 g00344117
Illustration 25 g00344116
Illustration 26 g00344114
Install shim (35) and the snap ring behind impeller (30). Install key (34), impeller (30), three shims (32) and snap ring (31) on shaft (33) .
Illustration 27 g00344113
Install seal (28) and snap ring (29) in front of impeller (30) .
Illustration 28 g00344112
Apply 1U-6396 O-Ring Assembly Compound to O-ring seal (27). Install O-ring seal (27) on cover (26) .
Illustration 29 g00344969
Illustration 30 g00344090
Install cover (26) and four bolts (25) on head (3). Install coupling (23) on the shaft. Apply 1U-6396 O-Ring Assembly Compound to O-ring seal (24). Install O-ring seal (24) on cover (24) .Note: O-ring seal (24) is not shown in the above illustration.
Illustration 31 g00344089
Illustration 32 g00344088
Install piston (22), retainer (21), spring (20) and retainer (19) in the pressure and flow compensator valve.
Install the setscrew and nut (16) in plug (17). Install plug (17) in pressure and flow compensator valve (2) .
Adjust pressure compensating valve (15) as close as possible to the original position.
Illustration 33 g00344087
Illustration 34 g00344086
Install piston (14), retainer (13), spring (12), spring (11) and retainer (10) in pressure and flow compensator valve (2) .
Install the setscrew and nut (7) in plug (8). Install O-ring seal (9) on plug (8). Install plug (8) in pressure and flow compensator valve (2) .
Adjust flow compensator valve (6) as close as possible to the original position.
Illustration 35 g00344085
Install two pins (4) and four O-ring seals (5) in pressure and flow compensator valve (2) .
Illustration 36 g00344082
Install five bolts (1) in order to secure pressure compensator valve (2) to steering pump (3). The torque for the five bolts is 21 5 N m (16 4 lb ft).Note: The flow compensator valve and the pressure compensator valve must be adjusted after the steering pump is installed on the machine. For the correct procedure, refer to the appropriate Testing and Adjusting manual for your machine.End By: Install the steering pump. Refer to Disassembly and Assembly, "Piston Pump (Steering) - Install".