ROD AS 3770607 - Caterpillar

Illustration 1 g03834463
Table 1
Specification for 470-8606 Wheel and Brake Gp    
Item    Qty    Part    Specification Description    
1     1     314-4130 Duo-Cone Seal Gp     Before assembly, rubber toric rings and all contacting surfaces must be clean at assembly. Apply a thin film of oil to the surfaces that contact the metal seals.    
2     1     365-4924 Duo-Cone Seal Gp     Before assembly, rubber toric rings and all contacting surfaces must be clean at assembly. Apply a thin film of oil to the surfaces that contact the metal seals.    
3     1     125-5938 Front Wheel     Before assembly, make sure that the rim mounting surface is free of paint and free of grease.    
4     1     7I-5617 Shim Pack     Shim Pack thickness is
5.55 0.08 mm (0.219 0.003 inch).
Note: See the Steering System Testing and Adjusting, "Front Wheel Bearing - Adjust" in order to determine the number of shims to use.    
5     6     8T-4196 Bolt     Before assembly, apply red Loctite 263 to the threads.
Torque to
30 7 N m (266 62 lb in).    
6     14     145-9278 Bolt     Note: Perform the procedure in the Steering System Testing and Adjusting, "Front Wheel Bearing - Adjust" before you install these bolts. Before assembly, apply blue Loctite 243 to threads. Then, tighten the bolts to the specified torque.    
7     12     8T-4194 Bolt     Before assembly, apply blue Loctite 243 to threads.    
Illustration 2 g03834495
Section B-B
Table 2
Item     Qty     Part     Specification description    
8     -     -     Stud and nut are only for the left side assembly. The right side assembly has a hole here.    
Illustration 3 g03834497
Right side view
Table 3
Item     Qty     Part     Specification description    
9     1     8X-2068 Plate     Plate thickness is
106.6 mm (4.20 inch).    
10     2     8X-2607 Shim Pack     Total thickness of shim pack is
6.0 mm (0.24 inch).
Thickness of each shim in the shim pack for six shims is
0.050 0.025 mm (0.0020 0.0010 inch).
Thickness of each shim in the shim pack for ten shims is
0.250 0.025 mm (0.0098 0.0010 inch).
Thickness of each shim in the shim pack for four shims is
0.80 mm (0.032 inch).    
11     12     177-9755 Bolt     Use the following procedure to tighten the bolts:
1. Assemble the suspension group and axle by bolting arm to strut rod using 3 bolts 120 degrees apart.
2. Tighten the bolts to
203 27 N m (150 20 lb ft).
3. Measure the distance between the plate and bottom of the strut rod.
4. Add the shim pack (10) equal to measured dimensions minus
8.60 0.03 mm (0.339 0.001 inch). Shim pack thickness must not be less than
0.64 mm (0.025 inch). Clearance expected between the shim pack and arm is
0.00 to 0.13 mm (0.000