ROD END-YOKE-YM 3775849 - Caterpillar

Illustration 1 g01088008
(1) Fuel filter base and electric priming pump (if equipped) (2) Fuel pump switch (3) Filter element (4) Bowl (5) Electrical connection for the electric priming pump (6) DrainNote: In order to open the self-ventilated drain, turn the plug counterclockwise. (7) PlugElectric Fuel Priming Pump (If Equipped)
Illustration 2 g01138383
(8) The arrows indicate direction of fuel flow. (9) Tighten the plugs to the following torque: ... 95 10 N m (70 7 lb ft) (10) Tighten the bolts to the following torque: ... 6.0 0.6 N m (55 5 lb in) (11) Tighten the plug to the following torque: ... 11 2 N m (8 1 lb ft) (12) Stud Apply 154-9731 Thread Lock Compound to the following distance from the top of the stud. ... 24.0 mm (0.9 inch) Tighten the stud to the following torque. ... 50 5 N m (37 4 lb ft)Dimension (A) ... 21.4 mm (0.84 inch) (13) Electrical connectionVoltage ... 24.0 2.0 VDCWater Separator and Primary Fuel Filter
Illustration 3 g01138402
Use the following procedure in order to assemble the water separator and fuel filter:
Remove bowl (4) from the bottom of fuel filter (3) .
Remove the O-ring seal from the bowl. Discard the O-ring seal.Note: Replacement filters include a new O-ring seal. Reuse bowl (4) and use a new O-ring seal whenever a new fuel filter is installed.
Lubricate the new O-ring seal with clean oil. Install the new O-ring seal in the groove of bowl (4) .
Thread the bowl (4) onto the bottom of fuel filter (3) and tighten the bowl to 15 N m (11 lb ft).