ROD AS 3956703 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 1P-0520 Bearing and Seal Driver 1
Illustration 1 g01214568
(X) Bucket control linkage
(Y) Sleeve bearing
Lower the temperature of the sleeve bearing. Use Tooling (A) to install the sleeve bearing in the linkage assembly. Install the sleeve bearing until Dimension (a) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the linkage assembly.
Illustration 2 g01214570
Use Tooling (A) in order to install lip seal (3). Install lip seal (3) with the sealing lip toward the outside of the linkage assembly. Install lip seal (3) until lip seal (3) makes contact with the sleeve bearing.
Repeat Steps 1 and 2 for the installation of the remaining lip seal and sleeve bearing.
Illustration 3 g01214571
(X) Bucket control linkage
(Y) Sleeve bearing
Lower the temperature of the sleeve bearing. Use Tooling (A) in order to install the sleeve bearing. Install the sleeve bearing until Dimension (b) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the linkage assembly.
Illustration 4 g01214572
Use Tooling (A) in order to install lip seals (2). Install lip seals (2) with the sealing lip toward the outside of the linkage assembly. Install lip seals (2) until lip seals (2) make contact with the sleeve bearing.
Repeat Steps 4 and 5 for the installation of the remaining lip seal and sleeve bearing.
Illustration 5 g01214576
(Y) Sleeve bearing
(Z) Stick
Lower the temperature of the sleeve bearing. Use Tooling (A) to install the sleeve bearing in the stick. Install the sleeve bearing until dimension (c) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the stick.
Illustration 6 g01214574
Use Tooling (A) to install lip seal (1). Install lip seal (1) with the sealing lip toward the outside of the stick. Install lip seal (1) until lip seal (1) makes contact with the sleeve bearing.
Repeat Steps 7 and 8 for the installation of the remaining lip seal and sleeve bearing. End By:
Install the bucket control linkage. Refer to Disassembly and Assembly, "Bucket Linkage - Install".