ROD ASSEM. 3D0013 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Illustration 1 g06354250
(A) 431-5111 Hose As or 432-9388 Hose As 431-5111 Hose As (A) in 465-6337 Steering Lines Gp (MT5 machines) and 432-9388 Hose As (A) in 461-4193 Steering Lines Gp (MN5 machines) is not properly retained on the machines listed above. A wiring harness is clipped at the location that the hose assembly should be clipped. The improper hose assembly routing can cause the hose assembly to rub on the edge of the hydraulic cabinet. This can result in a hose assembly failure. Refer to Illustration 1.Solution
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Caterpillar is aware of this problem and is recommending the following solution.
Illustration 2 g06338008
(A) 431-5111 Hose As or 432-9388 Hose As
Illustration 3 g06338004
(A) 431-5111 Hose As or 432-9388 Hose As
(1) 4K-8864 Clip
(2) 5M-3062 Bolt
(3) 8T-4896 Hard Washer
Table 1
Required Parts
Item Qty Part Number Part Name
1 1 4K-8864 Clip
2 1 5M-3062 Bolt
3 1 8T-4896 Hard Washer Remove clips from wiring harness. Refer to Illustration 1. Secure the hose assembly (A) using clip (1), bolt (2), and hard washer (3). Refer to Illustration 2 and Illustration 3.Note: Adjust wiring harness routing as required to eliminate interference with hose assembly.