ROD ASSEM. 3G3871 - Caterpillar

Illustration 1 g02998676
Illustration 2 g02634676
Table 1
Specification for 362-3939 Oil Pan Gp
Item Qty Part Specification Description
1 2 8T-6761 Pipe Plug Torque to 82 10 N m (60 7 lb ft).
2 1 5P-8068 O-Ring Seal Before assembly, lubricate the bore lightly with the fluid that is being sealed.
3 1 5P-5846 O-Ring Seal Before assembly, lubricate the bore lightly with the fluid that is being sealed.
4 40 2P-3205 Bolt Use the following procedure in order to tighten the bolt:
1. Tighten bolt 1 through bolt 40 in the numerical sequence as shown in Illustration 2 to 40 5 N m (30 4 lb ft).
2. Again, tighten bolt 1 through bolt 40 in the numerical sequence as shown in Illustration 2 to 47 5 N m (35 4 lb ft).
5 1 9X-6451 Drain Plug Torque to 70 15 N m (52 11 lb ft).
- - - Use the following procedure during assembly of engine oil pan:
The sealing surfaces of the oil pan shall be free of oil, debris, gasket material, or any other sealant.
The oil pan must be assembled and tightened to the cylinder block within 10 minutes of applying sealant.
1. Apply 3 to 5 mm (0.1 to 0.2 inch) ultra blue Loctite 587 to connecting joint of the front housing and the front of the cylinder block.
2. Apply 3 to 5 mm (0.1 to 0.2 inch) ultra blue Loctite 587 to connecting joint of the flywheel housing and the rear of the cylinder block.
3. Apply bead of ultra blue Loctite 587 to the gasket or to the housing face covering the entire span at T-joint location .