ROD-CONTROL 3K3491 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1
B 439-3938 Link Bracket 2
C - Loctite 243 - Start By:
Release the system pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01209599
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 2 g01216069
Disconnect hose assemblies (1), (2), and (3). Remove support (4).
Illustration 3 g01216082
Attach Tooling (B) and a suitable lifting device to swivel (9). The weight of swivel (9) is approximately 45 kg (95 lb). Remove bolts (6) and retainer (8). Remove clamp (7) and boot (5).
Illustration 4 g06320126
Disconnect hose assemblies (13). Disconnect fitting (14). Disconnect hose assemblies (10). Remove fittings (12). Remove bolts (11). Remove swivel (9).Installation Procedure
Install swivel (9) in the reverse order of removal.
Apply Tooling (C) between the mating surface of swivel (9) and the cover of the undercarriage.