ROD GROUP 3S0311 - Caterpillar

Petroleum TransmissionCX48-P2300 (S/N: GDH1-UP)Introduction
Table 1
Revision Summary of Changes in REHS3639
05 Updated Clutch Engagement, Table 4.
04 Updated Hose Assembly Installation.
Standardized.
03 Updated Tool Table 3.
Updated Introduction.
02 Updated Tool Table 3.
01 Updated Table 7 and Pressure Check steps.
00 Converted to SIS Authoring Format. © 2017 Caterpillar All Rights Reserved. This guideline is for the use of Cat dealers only. Unauthorized use of this document or the proprietary processes therein without permission may be violation of intellectual property law. Information contained in this document is considered Caterpillar: Confidential Yellow.This special instruction contains the necessary information that is required to bench test-specific transmission arrangements. Refer to Table 2 for the correct arrangements. Bench testing the transmission ensures correct assembly and operation of the component. Rotating a transmission provides the most conclusive evaluation. This action allows the dealer to ensure that the transmission will operate properly in the machine. The specifications in this guideline are specific to bench testing the component. Every effort has been made in order to provide the most current information that is known to Caterpillar. Continuing improvement and advancement of product design might have caused changes to your product which are not included in this publication. This guideline must be used with the latest technical information that is available from Caterpillar.For questions or additional information concerning this guideline, submit a form for feedback in the Service Information System. In order to address an urgent need, use the following resources to communicate your request to Caterpillar Repair Process Engineering:For technical questions when using this document, work with your Dealer Technical Communicator (TC).To report suspected errors, inaccuracies, or suggestions regarding the document, submit a form for feedback in the Service Information System (SIS Web) interface.
Table 2
Machine Model Transmission Arrangement
CX48-P2300 394-5695, 439-4770, 359-5427, 388-8735, 388-8745, 388-8750, 388-8755, 388-8760, 394-5700, 394-5705, 419-5650, 419-5655 Canceled Part Numbers and Replaced Part Numbers
This document may include canceled part numbers and replaced part numbers. Use NPR on SIS for information about canceled part numbers and replaced part numbers. NPR will provide the current part numbers for replaced parts.Important Safety Information
Illustration 1 g02139237Follow all safety warnings. Most accidents that involve product operation, maintenance, or repair are caused by failure to observe safety warnings. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. Personnel must be properly trained in order to perform maintenance, repair, or operate any machine. Safety precautions and warnings are provided this instruction and on Caterpillar products. These warnings should be observed before performing any procedures. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this publication and on the product are not all inclusive.The hazards are identified by the “Safety Alert Symbol” which is followed by a “Signal Word” such as “DANGER”, “” or “CAUTION”. The “” Safety Alert Symbol is shown in illustration below.
Illustration 2 g00008666This safety alert symbol means:Pay Attention!Become Alert!Your Safety is Involved.The message that appears under the safety alert symbol explains the hazard.Operations that may cause product damage are identified by ""