ROD AS 4734606 - Caterpillar

If the machine moved at a much lower engine rpm than specified or previously obtained while testing the brakes, consult your Caterpillar dealer for brake inspection and repair. Damaged brakes must be repaired before returning the machine to operation.
Batteries
Check the Electrolyte Level
According to your battery type, check the electrolyte level using the chart below. Tighten the battery retainers every 1000 hours on all batteries.Check the following at least every 1000 hours, and more often as conditions require:Clean the top of the batteries with a clean cloth.Keep the terminals clean and coated with petroleum jelly.At the proper charging rate, in a moderate climate, a battery should not require more than 30 cc (1 ounce) of water per cell per week. Check the cells weekly in extreme temperatures, cell water usage could be higher. 1. Unlatch and open the battery box cover.2. Clean the top of the batteries with a clean cloth. Keep the terminals clean and coated with petroleum jelly.3. Inspect the electrolyte level in each cell of each battery. Maintain the level to the bottom of the fill openings with distilled water. Close the battery box cover.Replacement of Battery, Battery Cable or Disconnect Switch
1. Turn the engine start switch to OFF. Turn all switches to the OFF position.2. Turn the battery disconnect switch to OFF and remove the key.3. Disconnect the battery cable, at the battery disconnect switch, that is connected to the machine frame. Do not allow the disconnected battery cable to contact the disconnect switch.4. Disconnect the negative battery cable at the battery.5. Make necessary repairs or battery replacement.6. Connect the negative battery cable at the battery.7. Connect the battery cable at the battery disconnect switch.8. Install key and turn the battery disconnect switch to ON.Cooling System
Change Coolant Conditioner Element
Refer to the "Cooling System Specifications" section of this manual for all cooling system requirements.To prevent engine damage, never add coolant to an overheated engine. Allow the engine to cool first.Use the 8T5296 Coolant Conditioner Test Kit to check for concentration.
Excessive coolant conditioner (greater than the recommended 6% initial fill) together with concentrations of antifreeze greater than 60% cause deposits to form and may result in radiator tube blockage and overheating.
The element is located on the left side of the machine. 1. Close the inlet valve and the outlet valve at the element base. Turn clockwise to close both vlaves.2. Remove the coolant conditioner element. Discard the element.3. Clean the element mounting base. Make certain all of the old element seal material is removed.4. Coat the seal of the new element with a thin film of clean engine oil or antifreeze.5. Install the element by hand. When the seal contacts the base, tighten it an additional 3/4 turn.6. Open the inlet valve and the outlet valve. Start the engine and check for leaks. Stop the engine.Belts - Fan and Alternator
Inspect-Replace
Inspect the condition and adjustment of the belts. Replace the belts if they are cracked or frayed. Replace the belts in sets if a belt is damaged.Apply a