ROD-CYLINDER 4907474 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Do not fill fuel filters with fuel before installing them. The fuel will not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel system parts. The fuel system should be primed prior to starting the engine.
This machine has two secondary fuel filters. Replace both filters at the same time by following the instructions below.
Open the engine access door on the right-hand side of the machine.
Illustration 1 g02953137
Secondary fuel filters.
Remove the used secondary fuel filter elements. Dispose of the used filter elements properly.
Clean the filter mounting bases. Make sure that all of the used seal is removed from each filter base.
Illustration 2 g00101318
Apply a thin coat of clean diesel fuel to the seal on each new fuel filter. Install each new fuel filter by hand until the seal of each fuel filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base. Note: There are rotation index marks on each fuel filter that are spaced 90 degrees or 1/4 of a turn away from each other. When you tighten each fuel filter, use the rotation index marks as a guide.
Tighten the filters according to the instructions that are printed on the filters. Use the index marks as a guide. For non-Caterpillar filters, use the instructions that are provided with the filter. Note: You may need to use a Caterpillar strap wrench, or another suitable tool, in order to turn the filters to the amount that is required for final installation. Make sure that the installation tool does not damage the filters.
Prime the fuel system. Reference: Refer to Operation and Maintenance Manual, "Fuel System - Prime" for the correct procedure.
Close the engine access door.