ROD ASSEM. 4F9092 - Caterpillar

Install Tool Bar Beam Assembly
Put 18 inch (45 cm) blocks under beam assemblyBack tractor up to beam Align brackets with draft members Install pins and cotter (two on each side)Locating Draft Members
2-3 inches (50-75 mm) clearance on each side Loosen bracket bolts Move brackets For correct clearance Tighten boltsBeam Adjustment
Beam must be parallel to ground when implement is at desired penetration depth Lengthen screws to decrease penetration Do not lengthen screw more than 51/2inches (140 mm). Shorten screws to increase penetration Lock handlesRemoving Tool Bar Beam Assembly
Put 18 inch (45 cm) blocks under beam assembly Remove adjusting screw cotter and pin (one on each side) Remove draft member cotter and pin (one on each side) Drive tractor awayInstalling Tool Bar Blade
Remove tool bar beam assembly and drive tractor ahead Swing draft frame arms to the front Attach diagonal braces to eyebolt on blade with pins and cotters With blade in vertical position and stand installed Drive tractor into position and install draft frame pins and cotters Install adjusting screw pins and cotters Attach diagonal braces to draft frame arms with pins and cotters Raise blade support standAdjusting Blade
To tilt blade: Shorten screw on side to be low Lengthen screw on side to be high Adjusting Blade
To tip blade: Shorten both adjusting screws to tip blade back Lengthen both adjusting screws to tip blade forward Toolbar - Do not lengthen screw more than 51/2 inches (140 mm). Bulldozer - Do not lengthen screw more than 5 inches (127 mm).Removing Blade
Lower support stand and blade Remove diagonal braces Remove cotters and pins from adjusting screws and draft frame Back tractor away