ROD AS 5133687 - Caterpillar

1. Remove the bolts (2) and washers that hold the oil pan plate to the flywheel housing. Loosen the bolts (1) that hold the oil pan to the cylinder block. 2. Fasten a hoist to the engine. Lift the engine and install shims (3) on each side of the engine between the cylinder block and the oil pan plate. 3. Remove the turbocharger oil drain tube (4) (if equipped with a turbocharger). 4. Fasten an approved lifting bracket to flywheel housing (5) and a hoist.5. Install two 1/2"-13 NC guide bolts (6) in the cylinder block as shown.6. Remove the bolts that hold the flywheel housing to the cylinder block. Remove the flywheel housing (5). The weight of the flywheel housing is 160 lb. (72 kg).Install Flywheel Housing
1. Clean the old gasket from the surfaces of the cylinder block and flywheel housing that make contact with each other. Put a new gasket in position. 2. Install two 1/2"-13 NC guide bolts (1) in the cylinder block as shown. Fasten tool (A) to the flywheel housing (2) and a hoist. Weight of the flywheel housing is 160 lb. (72 kg).3. Put a small amount of clean engine oil on the lip of the seal in the flywheel housing.
Be careful when the flywheel housing is installed so the seal is not damaged.
4. Put the flywheel housing (2) in position on the guide bolts (1). Install all but two bolts in the flywheel housing. Remove tool (A) and guide bolts (1). Install the other two bolts.5. Cut the bottom of the gasket off even with the flywheel housing and cylinder block. Put 5H2471 Gasket Cement on the bottom of the gasket where the gasket makes contact with the gasket for the oil pan plate. 6. Remove shims (3) from each side of the engine. Tighten all of the oil pan bolts. Install the bolts that hold the oil pan plate to the flywheel housing. 7. Install turbocharger oil drain tube (4) (if equipped with a turbocharger).end by:a) install flywheelb) install starting motor