ROD AS 5223910 - Caterpillar

1. Loosen hose clamp (1), and slide the hose from the breather cap.2. Remove all bolts (2) and the washers that hold valve cover (3) in position. Remove the valve cover. Remove the gasket from the valve cover if necessary.Install Valve Cover (3304)
1. Install a new gasket on the valve cover if needed. Apply 5H-2471 Cement on the contact surfaces of the gasket and valve cover when a new gasket is installed. 2. Put the valve cover in position on the cylinder head, and install the bolts that hold it. Tighten the bolts in the number sequence shown to a torque of 11 3 N m (8 2 lb ft).3. Slide the hose on the breather cap, and tighten the clamp that holds it.