ROD AS 6E1047 - Caterpillar

The CID 268 diagnostic code is associated with the configuration parameters of the Machine ECM. The FMI 02 means that the Machine ECM has determined that a configuration parameter is not correct or the configuration parameter is not programmed. The ECM will list the parameter that is causing the problem. The programmable parameters that may cause this code to activate are listed.
The sales model and product identification need programming.
The Machine ECM is incorrect.The sales model and product identification need programming.The correct sales model and product identification must be programmed when new software is flashed to the ECM.The Machine ECM is incorrect.All of the attachments for the machine are configured in the Machine ECM. The ECM activates the CID 268 FMI 02 diagnostic code when an attachment is configuration is incorrect.Test Step 1. Verify The Configuration Of The Sales Model
Use the Caterpillar ® Electronic Technician (Cat ® ET) to verify that the Machine ECM is configured to the default setting configuration. Expected Result:The Machine ECM has been configured correctly to the default setting configuration.Results:
YES - The Machine ECM has been configured correctly to the default setting configuration.Repair: Verify that the new configuration has corrected the problem before attempting to operate the machine.STOP
NO - The Machine ECM does not have the appropriate sales model and product identification. Proceed to Test Step 2.Test Step 2. Configure The ECM
Use Caterpillar ® Electronic Technician (Cat ® ET) to reset the configuration to the default setting configuration. Reset the installation status to the correct type for the attachments that are installed on the machine. Expected Result:The Machine ECM is configured to the default setting configuration.Results:
YES - The Machine ECM is configured to the default setting configuration.Repair: Verify that the new configuration has corrected the problem before attempting to operate the machine.STOP
NO - The Machine ECM is not configured to the default setting configuration.Repair: Repeat this procedure.If the diagnostic code remains active or repeatedly activated and no cause can be found, flash the ECM with the latest version of software. Ensure that you have the latest version of software for your specific machine and ECM. Refer to the Troubleshooting, "Electronic Control Module (ECM) - Flash Program" section of this manual for the correct procedure.If the problem is still present after flashing the latest software to the ECM, contact your Dealer Technical Communicator for a possible consultation with Caterpillar®.STOP