ROD AS 6E3109 - Caterpillar

Description
Illustration 1 g01287684
Location for the Board for the Flywheel Interface (1) Flywheel Interface BoardThe Flywheel Interface Board is the interface between the following components and the system controller: Load Cell, Top Bearing Temperatures, Temperatures (Field Coil), Armature Temperatures, Bottom Bearing Temperatures, Speed Sensing and Signals (Vibration).Removal Procedure
Refer to Systems Operation, Testing and Adjusting, RENR7654, "Internal Component Preremoval Steps (Flywheel Cabinet)" in order to shut down the system and gain access to internal components.
Electrostatic discharge can damage integrated circuits or semiconductors if you touch bus connector pins. When not in use, keep the module in its static-shield bag. Follow these guidelines when you handle any module:Touch a grounded object to discharge static potential.Wear an approved wrist-strap grounding device.Do not touch the bus connector or connector pins.Do not touch circuit components inside the module.If available, use a static-safe work station.
Illustration 2 g01287692
Diagram of the "Flywheel Interface" Board
Disconnect all connectors from the board (1). Verify each label for each connector for subsequent installation. Refer to Illustration 1.
Remove the three screws from the right side of the board (1) that connect the board (1) to the frame of the cabinet. Refer to Illustration 1.Installation Procedure
Electrostatic discharge can damage integrated circuits or semiconductors if you touch bus connector pins. When not in use, keep the module in its static-shield bag. Follow these guidelines when you handle any module:Touch a grounded object to discharge static potential.Wear an approved wrist-strap grounding device.Do not touch the bus connector or connector pins.Do not touch circuit components inside the module.If available, use a static-safe work station.
Position the board (1) on the frame of the cabinet on the right side of the cabinet. Refer to Illustration 1.
Install the three screws to the right side of the board (1). Install the board (1) to the frame of the cabinet.
Connect the wire connectors into the correct location on the board. Refer to Illustration 1.
Calibrate the board (1). Refer to Systems Operation, Testing and Adjusting, RENR7654, "Flywheel Load Cell - Calibrate".