ROD 6S4865 - Caterpillar

Seat Belt
Inspect for Damage
Always check the condition of the seat belts, seat tie down belts and mounting hardware before operating the machine. Replace any damaged or worn parts.Replace the seat belts after three years of use, regardless of appearance.1. Check the belt webbing (1) for wear or fraying. Replace if damaged.2. Check the buckles (2) for correct operation. The buckles should snap firmly shut and release promptly.3. Check that the seat belt hardware (3) and tie down belt hardware (4) are secure.Engine
Measure Oil Level
Do not overfill the crankcase to avoid engine damage.
1. Raise the hood. 2. With the engine stopped the oil level must be between ADD and FULL on dipstick (1).3. If necessary, remove filler cap (2) and add oil.4. Install the filler cap.Refer to the topics "Lubricant Specifications" and "Lubricant Viscosities and Refill Capacities".Cooling System
Check Coolant Level
1. Raise the hood. 2. Remove the expansion tank cap slowly to relieve pressure. Maintain the coolant level to the base of the filler neck. Coolant should always be visible.3. Clean and inspect the filler cap. If the seal is damaged, install a new one.4. Close the hood.If it is necessary to add make-up water daily, inspect for leaks.Refer to the topics "Cooling System Specifications" and "Lubricant Viscosities and Refill Capacities".Transmission
Measure Oil Level
Measure the transmission oil level with the machine level. The oil must be hot and the engine operating at low idle. The dipstick is located on the left side of the machine.1. Install the steering lock links (1).2. With the transmission oil at normal operating temperature, run the engine at low idle for five minutes to allow the oil level to stabilize.3. Check the oil level on the dipstick (2). The level must be between the LOW and FULL marks on the dipstick.4. If necessary, remove the filler cap (3) and add oil through the filler tube.5. Install the filler cap.6. Refer to the topics "Lubricant Specifications and Refill Capacities".Hydraulic Tank
Check Oil Level
The hydraulic oil level must be checked with the body fully lowered. 1. Check the oil level on the sight glass. The level must be in the middle of the sight glass.2. If necessary, slowly remove the filler cap and add oil.Refer to the topics "Lubricant Specifications" and "Lubricant Viscosities and Refill Capacities".Headlights, Turn Signals, Horn, Back-up Alarm, Indicators and Gauges
Test for Proper Function
1. Check that all gauges and indicators are intact. Replace any which are broken.2. Sound the horn to ensure it works.3. Operate the hazard light switch and machine lights to ensure they work.4. Turn the start switch to energise the electrical circuits but do not start the engine. Check that the indicators operate correctly.5. Shift the transmission to REVERSE and listen for the back-up alarm. Shift the transmission back to neutral.6. Start the engine and check that all indicators and gauges operate correctly.7. Check that the turn signals operate correctly.8. Have any faulty item repaired or replaced.Fuel Tank
Drain Water and Sediment
Do not fill the fuel tank to the top. Fuel expands as it