AVSPARE.COM
parts catalog

ROD-HOLDING 7H1945 - Caterpillar



7H1945 ROD-HOLDING Caterpillar parts ROD
Rating:
56
Alternative (cross code) number:
CA7H1945
7H-1945
7H1945
Caterpillar 7H1945 ROD-HOLDING
Weight: 0.30 pounds 0 kg.

Buy ROD-HOLDING 7H1945 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g03322444
Schematic for the secondaryBrake Accumulator pressure sensor
This diagnostic code is associated with the secondary Brake Accumulator pressure sensor. An FMI 20 means the Brake ECM has determined the data has drifted high, the sensor signal output is above normal.The sensor outputs a Pulse Width Modulated (PWM) active analog signal that informs the Brake ECM of the hydraulic pressure in the Brake Accumulator.Possible causes of this diagnostic code are:
The ECM believes that the Secondary Brake Accumulator Pressure sensor has Failed in Range.
There is a problem with the physical sensor.
The sensor has failed.
There is a problem with the hydraulic system whereby the Brake accumulators are not draining properly.
The Service Brake Accumulator sensor reports a difference in pressure exceeding 2345 kPa (340 psi), after the Brake Accumulators have completely purged, and the Engine is Not Running.
The Brake ECM may have failed, but is unlikely.Note: Poor connections are often the cause of a problem in electrical circuits. Before performing this procedure, inspect all the machine harnesses and connectors involved in the circuit. Make sure to verify that all of the connections in the circuit are clean, secure, and in good condition. Correct any problems found with any of the connections. Verify the diagnostic code CID 2813 FMI 20 is still active, before continuing with this procedure.Note: The following test procedure may create other diagnostic codes. Ignore all the created diagnostic codes now, but clear all those codes after the cause for the original diagnostic code has been corrected. Test Step 1. CHECK IF THE DIAGNOSTIC CODE REMAINS.
There is a problem with the physical sensor. Expected Result:The physical sensor is fine.Results:
YES - The physical sensor is fine. Proceed to step 2.
NO - The physical sensor is not fine.Repair: Repair or replace the physical sensor.See Testing and Adjusting, KENR8738, "793F BRAKING SYSTEM" or Testing and Adjusting, KENR8374, "797F BRAKING SYSTEM".STOPTest Step 2.
There is a problem with the hydraulic system whereby the Brake accumulators are not draining properly. Expected Result:The hydraulic system whereby the Brake accumulators are draining properly.Results:
YES - The hydraulic system whereby the Brake accumulators are draining properly. Proceed to step 3.
NO - The hydraulic system whereby the Brake accumulators are not draining properly.Repair: Troubleshoot the hydraulic system and the Brake accumulators. Repair or replace the faulty parts.See Testing and Adjusting, KENR8738, "793F BRAKING SYSTEM" or Testing and Adjusting, KENR8374, "797F BRAKING SYSTEM".STOPTest Step 3.
Inspect the contacts of the harness connectors and clean the connectors. Check the wires for damage to the insulation that is caused by excessive heat, corrosion, or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the sensor circuit.
Turn the disconnect switch and the key start switch to the ON position.
Clear all inactive diagnostic codes.
Operate the machine.
Check the status of the CID 2813 FMI 20 code. Expected Result:The CID 2813 FMI 20 diagnostic code is active.Results:
YES - The CID 2813 FMI 20 diagnostic code is active.Repair: It is unlikely that the Brake ECM has failed. Exit this procedure and perform


Parts rod Caterpillar catalog:

7H1376 ROD
Caterpillar
7H2120 ROD
Caterpillar
7H2111 ROD
Caterpillar
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.