ROD ASSEM. 7J7527 - Caterpillar

This diagnostic code is associated with the AutoCarry or AutoRip Enable switch on the Remote Control Operator console.The FMI 02 means that the ECM has determined that the "Normally Open" and "Normally Closed" circuits are in the same state.Note: The following test procedure may create other diagnostic codes. Ignore these diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1873 FMI 02 is active before performing this procedure.Note: The Operator Console and Remote Control Machine must be linked and communicating to perform this troubleshooting procedure (Blue light on the machine is on and flashing). Test Step 1. VISUALLY INSPECT THE AUTOCARRY OR AUTORIP ENABLE SWITCH
Inspect the switch.
Operate the switch to ensure proper operation. Note: Refer to the Systems Operation Section for operation instructions.Expected Result:Switch is in good working condition.Results:
Yes - Switch is in good working conditionRepair: If the code remains active, contact the Cat Dealer to report/record the diagnostic code.STOP
No - Switch is not operating properly. The cause of the problem is uncertain.Repair: Contact Caterpillar technical support with the information that has been gathered.STOP