ROD 8H9739 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
ZZ 6V-9511 Plug 7
6V-9832 Cap As 7 Start By:
Remove the gear pump (vibratory). Refer to Disassembly and Assembly, "Gear Pump (Vibratory) - Remove".
Remove the piston pump (left drag conveyor and right auger conveyor). Refer to Disassembly and Assembly, "Piston Pump (Left Drag Conveyor and Right Auger Conveyor) - Remove". Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01051197
Disconnect three harness assemblies (1).
Illustration 2 g01051200
Remove the cable straps and move harness assembly (2) out of the way.
Illustration 3 g01051201
Remove the coupler from the splines of pump (4), as shown.
Disconnect hose assemblies (3) from pump (4).
Illustration 4 g01051212
Disconnect five hose assemblies (5) from pump (4).
Illustration 5 g01051214
Attach a suitable lifting device to pump (4). Remove bolts (6) and remove the pump. The weight of the pump is approximately 76 kg (168 lb).