ROD ASSEM. 9J4870 - Caterpillar

Troubleshooting
Perform the following steps to troubleshoot an event:
Obtain the following information from the operator:
The event and the time of the event
Determine the operating conditions at the time of the event
Determine if there are any systems that were installed by the dealer or by the customer that could cause the event
Verify that the event is not due to normal machine operation or operator error.
Check all fluid and oil levels.
Troubleshoot and repair the cause of any active diagnostic codes.VIMSTM Event Code List
The following table lists the event codes that apply to the VIMSTM control system. The recommended operator response is listed. Use Cat ET to determine the active or logged event codes.Note: For a comprehensive list of Power Train Electronic Control System, Braking System, Chassis Electronic Control System, and VIMS, Monitoring, and Payload fault codes: Refer to Special Instruction, M0074080, "Event Code List for 793F and 797F Off-Highway Trucks".
Table 2
MID 161
(VIMS Main ECM Event Codes)
Event Code Warning Level Warning Description Required Operator Action
558 1 VIMS Snapshot Stored Service Soon
559 1 Event List Memory Low Download Data
1087 1 VIMS Trend Memory Low Download and Reset Data
1088 2 VIMS Trend Memory Full Download and Reset Data
1189 1 File System Memory Low Download Soon
1189 2 File System Memory Full Download immediately
2139 1 VIMS Snapshot Memory Full Download and Reset Data
Table 3
MID 162
(VIMS Application ECM Event Codes)
Event Code Warning Level Warning Description Required Operator Action
237 2 Machine Overloaded Dump Load Safely
689 2 High Front Tire Temp Slow Down
690 2 High Rear Tire Temp Slow Down
691 2 Speed Limited - High Tire Temp Slow Down
697 1 Negative High Peak Frame Bias Slow Down, Avoid Area
697 2 Negative High Peak Frame Bias Slow Down, Avoid Area
698 1 Positive High Peak Frame Rack Slow Down, Avoid Area
698 2 Positive High Peak Frame Rack Slow Down, Avoid Area
699 1 Negative High Peak Frame Rack Slow Down, Avoid Area
699 2 Negative High Peak Frame Rack Slow Down, Avoid Area
700 1 Negative High Peak Frame Pitch Slow Down, Avoid Area
700 2 Negative High Peak Frame Pitch Slow Down, Avoid Area
777 1 Positive High Peak Frame Bias Slow Down, Avoid Area
777 2 Positive High Peak Frame Bias Slow Down, Avoid Area
779 1 Positive High Peak Frame Pitch Slow Down, Avoid Area
779 2 Positive High Peak Frame Pitch Slow Down, Avoid Area
1189 1 File System Memory Low Download Soon
1189 2 File System Memory Full Download Immediately
2079 2 LF Suspension Cylinder Low Service Required
2080 2 RF Suspension Cylinder Low Service Required
2081 2 LR Suspension Cylinder Low Service Required
2082 2 RR Suspension Cylinder Low Service Required
2083 1 Payload Memory Low Download and Reset Data
2083 2 Payload Memory Full Download and Reset Data
2126 1 Machine Overloaded Dump Load Safely
2126 2 Machine Overloaded Dump Load Safely