ROD 9V6374 - Caterpillar

Illustration 1 g01215300
Illustration 2 g01215303
Attach a suitable lifting device to both ends of stick cylinder (1). The weight of stick cylinder (1) is approximately 325 kg (715 lb).
Disconnect hose assemblies (4). Remove bolt (3) and pin assembly (2). Remove bolt (5) and pin assembly (6).
Remove stick cylinder (1). Disassembly and Assembly Information
Table 1
Required Tools
Tool Part Number Part Description Qty
A 127-4904 Hydraulic Cylinder Repair Stand Gp 1
1P-0520 Driver Gp 1
9U-7868 Spanner Wrench 1
127-8064 Adapter Plate Gp 1
195-4609 Seal Pick 1
B 4C-4032 Bearing Mount Compound 1
C 5P-0960 Grease Cartridge 1
D 1P-1837 Bearing Puller Adapter 1
4C-9633 Puller Stud 1
1A-1935 Full Nut 1
3S-6224 Electric Hydraulic Pump Gp 1
6V-3175 Double Acting Cylinder 1
6V-2098 Press Sleeve 1 Note: Tooling (D) is used for the removal of the bearings that are located at the head end and the rod end of the cylinder.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 3 g01174095Note: Apply a light film of hydraulic oil to all components before assembly.
Apply Tooling (B) to seal (1) prior to assembly.
Apply clean hydraulic oil on the lip of seal (1), seal (2), and seal (3).
Apply Tooling (C) to the threads of head (5).
Lubricate the threads of rod assembly (7) with Tooling (C).
Tighten piston (8) to a torque of 12300 615 N m (9072 454 lb ft). Note: For cylinders equipped with a lock nut, lubricate all threads and the face. Tighten the lock nut to a torque of 10800 550 N m (7965 406 lb ft).
Install ball (10) and setscrew (9) in locknut (8). Tighten setscrew (9) to a torque of 57 10 N m (42 7 lb ft).
Lubricate the outside of piston (6) with Tooling (C).
For M20 bolts (4), tighten to a torque of 520 78 N m (384 58 lb ft). Note: For cylinders with M24 bolts (4), tighten to a torque of 800 100 N m (590 74 lb ft).Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
E 5P-0960 Grease Cartridge 1
Illustration 4 g01215300
Illustration 5 g01215303
Attach a suitable lifting device to both ends of stick cylinder (1). The weight of stick cylinder (1) is approximately 325 kg (715 lb). Position stick cylinder (1) onto the machine.
Apply Tooling (E) to pin assembly (2). Install pin assembly (2) and bolt (3). Apply Tooling (E) to pin assembly (6). Install pin assembly (6) and bolt (5).
Connect hose assemblies (4).
Fill the hydraulic oil tank. Refer to Operation and Maintenance Manual, "Hydraulic Oil Level - Check".