ROLL-ABRASIVE 1U8277 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Bostik Pure Nickel Anti-Seize Compound 1 Start By:
Remove the left side engine enclosure.
Illustration 1 g02520941
View from the left rear of the engine
Slide locking tab (2) (not shown) into the unlocked position. Disconnect harness assembly (1) and harness assembly (4) for the temperature sensor (cooled exhaust gas).
Cut cable straps (5) and cable strap (3).
Remove temperature sensor (cooled exhaust gas) (6) from tube assembly (7).Installation Procedure
Install temperature sensor (cooled exhaust gas) (6) in the reverse order of removal.
Ensure that the harness assembly is correctly routed and the cable straps are not over-tightened. Over-tightening of the cable straps will damage the harness assembly.
Lightly lubricate the threads of temperature sensor (cooled exhaust gas) (6) with Tooling (A).
Torque temperature sensor (cooled exhaust gas) (6) to a torque of 45 5 N m (33 4 lb ft) for ferrous ports.
Torque temperature sensor (cooled exhaust gas) (6) to a torque of 24 3 N m (212 27 lb in) for non-ferrous ports.