ROLL 4C6734 - Caterpillar

(1) Diameter of gear bore for bearing ... 60.163 0.015 mm (2.3686 .0006 in) Diameter of shaft for idler gear ... 55.047 0.020 mm (2.1672 .0008 in)(2) Gear assembly (Idler gear).(3) Air compressor drive gear.(4) Front face of the block.(5) Front timing gear housing.(6) Camshaft.(7) Water pump drive gear.(8) Front face of block. Diameter of shaft for idler gear ... 69.321 0.020 mm (2.7292 .0008 in)(9) Oil pump drive gear.(10) Idler gear.(11) Crankshaft.(12) Crankshaft gear. Heat gear to a maximum temperature of 316°C (601°F) for installation.(13) Idler gear. Diameter of gear bore for bearing ... 74.452 0.015 mm (2.9312 .0006 in)(14) Hydraulic pump drive gear.(15) Align timing marks on idler gear with marks on crankshaft and camshaft gear as shown.
Typical Example of Gear Assembly for Idler Gears(16) Inside diameter of bearing [installed in idler gear (12)] ... 55.163 0.041 mm (2.1718 .0016 in) Inside diameter of bearing [installed in idler gear (10)] ... 69.452 0.041 mm (2.7343 .0016 in)(17) Gear.(18) Bearing.(19) Distance between front face of bearing in gear bore and front face of gear [idler gear (12)] ... 1.00 0.25 mm (.039 .010 in) Distance between front face of bearing in gear bore and front face of gear [idler gear (10)] ... 1.00 0.25 mm (.039 .010 in)