ROLLER GP- 1181614 - Caterpillar

Check if control pattern 1 (Standard) or control pattern 2 (Alternate) is selected before operating the machine.Refer to Operation and Maintenance Manual.Failure to understand control functions could result in injury or death.
Joystick Control Selector (If Equipped)
Illustration 1 g03109577On machines which are equipped with a pattern changer, the operator stand has two covers (A) which give access to the patter changer.
Illustration 2 g03109584The machine may be equipped with a joystick control selector. The machine control pattern can be varied by switching the position of the rod linkage (B). Position (1) is the factory setting. This is the standard position. Position (2) is the alternate position. The alternate position allows the operator to change the functions of the joysticks.
Flip cover (A) upwards.
Push the self retaining bushing (C) on the rod linkage (B) upwards, in order to release the ball seat from the ball stud.
Keep the self retaining bushing pushed upwards and move rod linkage (B) to either ball stud (1) or ball stud (2) and mount the ball seat to the ball stud.
Release the self retaining bushing and make sure that the ball seat is locked with the ball stud.
Put the cover (A) back in place.
Flip the second cover (A) upwards and repeat step 2 to 5. Alternate Joystick Control Pattern
The machine control pattern is set at the factory to the "SAE J1177" and "ISO10968" pattern for an excavator.
Illustration 3 g02465576
BOOM LOWER (1) - Move the joystick to this position in order to lower the boom.
SWING RIGHT (2) - Move the joystick to this position in order to swing the upper structure to the right.
BOOM RAISE (3) - Move the joystick to this position in order to raise the boom.
SWING LEFT (4) - Move the joystick to this position in order to swing the upper structure to the left.
STICK OUT (5) - Move the joystick to this position in order to move the stick outward.
BUCKET DUMP (6) - Move the joystick to this position in order to dump the bucket or the work tool.
STICK IN (7) - Move the joystick to this position in order to move the stick inward.
BUCKET CLOSE (8) - Move the joystick to this position in order to close the bucket or the work tool.HOLD (9) - When you release the joystick from any position, the joystick will return to the HOLD position. Movement of the structure will stop.Two functions may be performed at the same time by moving the joysticks diagonally.