ROLLER GP-TRACK-DOUBLE FLANGE 1210827 - Caterpillar

Refer to the Owner's Manual of the OEM for your type of controls. Use the following procedure to start the engine.
DO NOT USE ETHER (starting fluids) unless specifically instructed to do so. If the engine is equipped with an Air Inlet Heater (electrically or fuel ignited manifold heater), DO NOT use ether (starting fluids) at any time. The use could result in engine damage and/or personal injury.
Startability will be improved at temperatures below 0° C (32° F) from the use of a jacket water heater or from other means that are used to heat the crankcase oil. This will help reduce white smoke and misfire during start-up in cold weather.
When using ether (starting fluid), follow the manufacturer's instructions carefully, use it sparingly and spray it only while cranking the engine. Excessive ether can cause piston and ring damage. Use ether (starting fluid) for cold weather starting purposes only.
For engines that are not equipped with an Air Inlet Heater, use ether when temperatures are below 0° C (32° F). If the engine is equipped with an injection system for starting fluid, crank the engine. Depress the ether switch for three seconds. Additional injections may be necessary in order to start the engine.Note: If the engine has not been run for several weeks, fuel may have drained. Air may have moved into the filter housing. Also, when fuel filters have been changed, some air will be left in the filter housing. Refer to the Operation and Maintenance Manual, "Fuel System - Prime" topic (Maintenance Section) for more information on priming the fuel system.
Do not engage the starting motor when flywheel is turning. Do not start the engine under load.If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
Place the transmission in NEUTRAL. Disengage the flywheel clutch in order to allow the engine to start faster. This also reduces draining of the battery.
Turn the keyswitch to the ON position. The "CHECK ENGINE/DIAGNOSTIC" lamp will flash while the engine is cranking. The lamp should turn off after proper engine oil pressure is achieved. If the lamp fails to flash, notify your authorized Caterpillar dealer. If the lamp continues to flash, the Electronic Control Module (ECM) has detected a problem in the system. Refer to the Operation and Maintenance Manual, "Features and Controls" topic (Operation Section) for more information.
Push the start button or turn the keyswitch to the START position in order to crank the engine. Do not push down or hold the throttle down while the engine is cranked. The system will automatically provide the correct amount of fuel that is needed to start the engine.
If the engine fails to start within 30 seconds, release the start button, or the keyswitch. Wait for two minutes in order to allow the starting motor to cool before attempting to start the engine again.
Oil pressure should rise within 15 seconds after the