ROLLER GP-SFLG 1231186 - Caterpillar

Illustration 1 g03576636
Use a suitable lifting device to place the swing drive on table. The weight of the swing drive is approximately 84 kg (185 lb).
Remove sun gear (1) from carrier assembly (2).
Remove carrier assembly (2) from ring gear (3).
Illustration 2 g03576957
Remove retaining ring (4). Remove thrust washer (5) and planetary gear (6).
Illustration 3 g03576977
Illustration 4 g03576996
Remove bearing assembly (6) and thrust washer (7).
Drive spring pin (9) into shaft (8). Remove shaft (8) from carrier assembly (2).
Repeat Steps 4 through 6 for the remaining planetary gears.
Illustration 5 g03577121
Illustration 6 g03577158
Remove sun gear (10) from the planetary carrier assembly.
Remove ring gear (11) from housing (12).
Illustration 7 g03577196
Remove planetary carrier assembly (13) from the pinion shaft.
Illustration 8 g03577357
Drive spring pin (15) into shaft (14) to remove shaft (14) and the planetary gear assembly.
Illustration 9 g03577616
Remove shaft (14), thrust washer (16), bearings (17), planetary gear (18), and thrust washer (19). Repeat Steps 11 through 12 for the remaining planetary gear assemblies.
Illustration 10 g03577639
Turn the housing and the pinion shaft assembly over and remove plates (20).
Illustration 11 g03578221
Remove retaining ring (21) to remove pinion shaft (22).
Illustration 12 g03578226
Use a suitable press to remove pinion shaft (22) from the bearings and housing assembly (12).Note: Take some precaution to prevent the pinion shaft from dropping out of the bottom.
Illustration 13 g03578276
Illustration 14 g03578319
Remove bearing (23) and seal (24) from the housing.
Illustration 15 g03578476
Use Tooling (A) and a suitable press to remove bearing assembly (25) from pinion shaft (22). Support Tooling (A) with suitable blocks. Place support under pinion shaft (22) to keep from dropping to the floor.