ROLLER GP-TRACK-SINGLE FLANGE 1248250 - Caterpillar

There may be several specific warning signs on an engine. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiar with all warning signs.Ensure that all of the warning signs are legible. Clean the warning signs or replace the warning signs if the words cannot be read or if the pictures are not visible. When the warning signs are cleaned, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the warning signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the warning signs. The warning signs that are loosened could drop off of the engine.Replace any damaged warning signs or missing warning signs. If a warning sign is attached to a part of the engine that is replaced, install a new warning sign on the replacement part. Any Caterpillar dealer can provide new warning signs.
Do not operate or work on this engine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
The warning labels that may be found on the engine are illustrated and described below.Battery
Illustration 1 g00454398
The warning label for the battery should be installed on the side of the engine or in a visible location near the batteries. If the batteries are located on both sides of the package, the warning label should be located on both sides of the engine.
g00455028
Improper jumper cable connections can cause an explosion resulting in personal injury.
Batteries may be located in separate compartments. When you are using jump start cables, always connect the positive "+" cable to the positive "+" terminal of the battery that is connected to the starter solenoid. Connect the negative "-" cable from the external source to the negative "-" terminal of the starter. If the engine is not equipped with a negative "-" terminal on the starter, connect the negative "-" cable from the external source to the engine block. Follow the procedure in this Operation and Maintenance Manual.