ROLLER 1K6760 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Dirt and contaminants can damage precision components that are in pumps and motors. All disassembly and assembly procedures must be performed on a clean work surface. Clean all the interior components in clean solvent. Dry all the interior components with compressed air. Plug ports and plug hoses on the machine during repair.
Illustration 1 g01004682
Install seal (29) to housing (4) .
Install seals (28) to housing (4) .
Install seal (27) to housing (4) .
Illustration 2 g01004683
Illustration 3 g01004698
Install housing (4) to rotor (5) .
Install distributor (3) to housing (4) .
Install bolts (26) to distributor (3) .
Illustration 4 g00992145
Install collar (24) and pin (25) to distributor (3) .
Install O-ring seals (23) and fittings (22) to collar (24) .
Install O-ring seals (21) to distributor (3) .
Illustration 5 g00991943
Install rotor (2) to distributor (3). Install pin (18), lockwasher (19), and nut (20) to distributor (3).
Illustration 6 g00991939
Install slip rings (14), O-ring seals (15), ring (16), and ring (17) to the inside of housing (1) .
Illustration 7 g00992014
Install setscrew (13) and nut (12) to housing (1) .
Install seal (11) to housing (1) .
Install housing (1) to the rotor.
Illustration 8 g00991917
Install seal (10) and cover (9) to housing (1) .
Install O-ring seals (7), rings (8), and bolts (6) to cover (9) .End By: Install the swivel. Refer to Disassembly and Assembly, "Swivel - Install ".