ROLLER GP-TRACK 3468807 - Caterpillar

Image1.1.1
Image1.1.2
Torque values for wheel drive machines
Torque value for fasteners (A) 400 +/- 50 Nm (295 +/- 37 ft lbs)
Torque value for fasteners (B) 400 +/- 50 Nm (295 +/- 37 ft lbs)
Torque value for fasteners (C) 560 +/- 60 Nm (413 +/- 44 ft lbs)
Image1.2.1
Torque values for track drive machines
Torque value for fasteners (D) 530 +/- 70 Nm (390 +/- 52 ft lbs)
Torque value for fasteners (E) 460 +/- 60 Nm (340 +/- 44 ft lbs)
Torque value for fasteners (F) 560 +/- 60 Nm (413 +/- 44 ft lbs)
Image1.3.1
9) Ensure the propel motors are installed on the side in which they were removed.
10) Prior to installing the tracks or the wheels on the machine operate the propel system. Cycle the propel system in the following sequence:
Forward, low engine idle, pave mode, full propel for 10 minutes
Reverse, low engine idle, pave mode, full propel for 10 minutes
Forward, low engine idle, travel mode, full propel for 10 minutes
Reverse, low engine idle, travel mode, full propel for 10 minutes
Inspect the planetary for any leaks prior to proceeding.
11) After the machine is returned to an operational condition, verify the machine tracks straight as noted in the "Pump Synchronization" test located in the test and adjust manuals. Also, verify the machine initial current calibrations are correct by checking for skewing when propelling the machine as noted in the propel systems troubleshooting manuals.
Reference the following service manual modules for disassembly and assembly for the respective machine models:
AP-655C
Disassembly and Assembly
AP-655C Asphalt Pavers Machine Systems Media Number -KENR5033-00
Screed - Remove and Install
Tow Arm - Remove and Install
Belt - Remove
Wheel (Final Drive) - Remove and Install
Final Drive Planetary - Remove
Final Drive Planetary - Disassemble
Duo-Cone Conventional Seals - Install
Final Drive Planetary - Assemble
Final Drive Planetary - Install
Belt ? Install
AP-655D
Disassembly and Assembly
AP655D Asphalt Pavers Machine Systems Media Number -KENR6002-00
Screed - Remove and Install
Tow Arm - Remove and Install
Belt - Remove
Wheel (Final Drive) - Remove and Install
Final Drive Planetary - Remove
Final Drive Planetary - Disassemble
Duo-Cone Conventional Seals - Install
Final Drive Planetary - Assemble
Final Drive Planetary - Install
Belt - Install
AP-1000D
Disassembly and Assembly
AP-1000D and BG-260D Asphalt Pavers Media Number -KENR5069-00
Screed - Remove and Install
Tow Arm - Remove and Install
Wheel (Rear) - Remove and Install
Final Drive Planetary - Remove
Final Drive Planetary - Disassemble
Duo-Cone Conventional Seals - Install
Final Drive Planetary - Assemble
Final Drive Planetary ? Install
AP-1055D
Disassembly and Assembly
AP-1055D and BG-2455D
Asphalt Pavers Machine Systems Media Number -KENR5048-00
Screed - Remove and Install
Tow Arm - Remove and Install
Belt - Remove
Wheel (Final Drive) - Remove and Install
Final Drive Planetary - Remove
Final Drive Planetary - Disassemble
Duo-Cone Conventional Seals - Install
Final Drive Planetary - Assemble
Final Drive Planetary - Install
Belt - Install