ROLLER GP-TRACK-DOUBLE FLANGE 3650751 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02704316
Ensure that cooler matrix (5) is clean, free from restriction, and free from damage. Ensure that spacer plate (7) is clean and free from damage. Replace any damaged components.
Position a new joint (6) onto spacer plate (7). Install cooler matrix (5) to the spacer plate.
Install bolts (4) finger tight. Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Studs
(M8 by 70 mm) 2
Clean the gasket surface of the cylinder block.
Illustration 2 g02721610
Illustration 3 g02704416
Tightening sequence for an engine oil cooler
Position a new gasket (3) (not shown) onto the assembly of engine oil cooler (2). Install bolts (1) to the serrated holes in the gasket. Note: Ensure that the bolts of different length are installed in the correct position.
Install Tooling (A) to the cylinder block.
Install the assembly of oil cooler (2) onto Tooling (A) . Ensure that the assembly of the oil cooler is correctly located into the recess of the cylinder block.
Tighten bolts (1) finger tight.
Remove Tooling (A).
Install remaining bolts (1) to assembly of engine oil cooler (2).
Tighten bolts (1) to a torque of 22 N m (195 lb in) in the sequence that is shown in Illustration 3.
Install the oil filter base. Refer to Disassembly and Assembly, "Oil Filter Base - Remove and Install" for the correct procedure.
Fill the cooling system to the correct level. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
Check the level of the engine lubricating oil. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check" for the correct procedure.