ROLLER GP-TRACK CARRIER 3P3403 - Caterpillar

OP5 is the option for programming the engine/generator setpoints. The engine/generator setpoints affect the proper operation and serviceability of the engine, and the accuracy of information shown on the display. The setpoints are programmed in the GSC at the factory.The setpoints may require changing when the GSC is moved from one engine to another engine. Customer requirements and moving the GSC from one engine to another engine may require changes in the setpoints. The setpoints that are stored in the GSC must match the specified setpoints of the particular generator set. The setpoints are P01 to P24 and the setpoints are programmable. The setpoints are described in Table 1.Procedure For Engine/Generator Programming
Note: Service Mode cannot be entered when the ECS is in the AUTO position.Note: Any active shutdown fault (any shutdown indicator FLASHING) must be made inactive in order to access service mode. To temporarily change a shutdown fault from an active shutdown fault to an inactive shutdown fault, the shutdown fault must be no longer occurring. The fault must be corrected and the ECS must be turned to the OFF/RESET position. If the jumper from terminal 6 to terminal 9 is not installed on the ECS, the GSC does not power up in the OFF/RESET position and any active shutdown fault must be corrected before entering service mode.
Turn the ECS to the STOP position in order to shut down the engine. Enter service mode and enter the password. OP 1 is showing on the lower display. See Systems Operation, "Procedure To Enter The Password" that is located within the topic Password Entry OP3 for more information.
Press "SCROLL UP" key again. OP5 is showing on the lower display.
Press "SELECT" key again. P01 is showing on the display. P01 is followed by the value of the setpoint.
Press the "SCROLL UP" key or the "SCROLL DOWN" key. The next setpoint is showing with the value of the setpoint. Repeat this step until the desired setpoint is showing.
Press the "SELECT" key. The value of the setpoint is flashing.
Press the "SCROLL UP" key or "SCROLL DOWN" key in order to adjust the value of the setpoint.Note: Press and hold the appropriate "SCROLL" key in order to rapidly scroll through a large range of values.
Press the "ENTER" key. The value of the setpoint stops flashing. Repeat steps 4, 5, 6 and 7 until all the desired setpoints are adjusted.
Press "EXIT" key. "OP 1" is showing on the lower display.
Press "EXIT" key. The display will return to the normal mode.
Table 1
OP5 Setpoints - Engine/Generator Programming (1)    
Setpoint    Name    Description    Range Of Value    Factory Default    
P01     Fuel Solenoid Type     Type of fuel system solenoid used on the generator set.     0 - ETR fuel solenoid
1 - ETS fuel solenoid     0    
P02     Units Shown     Type of measurement units shown on the GSC display.     0 - English units (psi, degrees F)
1 - Metric units (kPa, degrees C)     0    
P03     Shutdown Override