ROLLER ASSEM. 4M8262 - Caterpillar

Removal Procedure
Start By:
Remove the valve mechanism cover. Note: Do not disassemble the variable valve actuator after the component has been removed. Any attempt to disassemble the variable valve actuator will void the warranty of the component.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01446246
Disconnect harness assembly (4). Disconnect harness assembly (1) .
Remove bolt (2). Remove four nuts (3) and two nuts (6) .
Remove variable valve actuator (5) .
Illustration 2 g01446248
Remove support (11) and stud (10) .
Remove two studs (9) and three studs (7) .
Remove rocker arm assembly (8) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01446248
Illustration 4 g01446408
Install two studs (9) at Location 6 and Location 7. Tighten studs (9) to a torque of 47 9 N m (35 7 lb ft).
Install stud (10) at Location 2. Tighten stud (10) to a torque of 65 10 N m (48 7 lb ft). Install support (11) .
Position rocker arm assembly (8). Install three studs (7) at Location 3, Location 4, and Location 5. Tighten studs (7) to a torque of 50 5 N m (37 4 lb ft). Turn studs (7) for an additional 45 5 degrees.
Illustration 5 g01446246
Install variable valve actuator (5) .
Install bolt (2). Install four nuts (3). Install two nuts (6). Refer to the tightening sequence.
Tighten bolt (2) to a torque of 105 20 N m (77 15 lb ft). Tighten nuts (3) to a torque of 105 20 N m (77 15 lb ft). Tighten nuts (6) to a torque of 47 9 N m (35 7 lb ft). Tighten the nuts and the bolt in a numerical sequence.
Connect harness assembly (4). Connect harness assembly (1) to variable valve actuator (5) .
Illustration 6 g01446444
First adjust the lash on the exhaust and then adjust the compression brake on variable valve actuator (5). Refer to Testing and Adjusting, "Compression Brake Lash - Adjust" for more information on adjusting the lash for the compression brake. Tighten jam nut (12) to a torque of 15 3 N m (11 2 lb ft).End By: Install the valve mechanism cover.