ROLLER GP-TRACK-DOUBLE FLANGE 7T5029 - Caterpillar

The rotation of the shaft is clockwise when viewed from drive end.For testing purposes, use SAE 10W oil at 65 °C (150 °F).
Illustration 1 g03043137
(1) Implement pump section (2) Steering pump section (3) Pilot and braking pump sectionIntroduction
This test is designed to determine whether a pump is operating within design parameters. This test should be performed only if all cylinder cycle times are too slow.For any pump test, the pump flow at 690 kPa (100 psi) will be larger than the pump flow at 6900 kPa (1000 psi) if the pump is operating at the same rpm. The pump flow is measured in L/min (US gpm).The difference between the pump flow of two operating pressures is the flow loss.Note: The values in the examples are not set values for any specific pump or for any specific pump condition. See the Specification for the pump flow of a new pump at 690 kPa (100 psi) and at 6900 kPa (1000 psi).
Table 4
Method of determining flow loss    
    Pump flow at
690 kPa (100 psi)    
−     Pump flow at
6900 kPa (1000 psi)    
    Flow loss    
Table 5
Example of determining flow loss    
   
217.6 L/min (57.5 US gpm)    
−    
196.8 L/min (52.0 US gpm)    
   
20.8 L/min (5.5 US gpm)    Flow loss that is expressed as a percentage of pump flow is used as a measure of pump performance.
Table 6
Method of determining percent of flow loss    
Flow loss (L/min or US gpm)     ×     100     =     Percent of flow loss    
Pump flow at
690 kPa (100 psi)    
Table 7
Example of determining percent of flow loss    
20.8 L (5.5 US gal)     ×     100     =     9.5%    
217.6 L/min (57.5 US gpm)    Test Preparation
Illustration 2 g03075256
Steering frame lock installed (4) Steering frame lock
Install the steering frame lock (4). ReferenceRefer to Operation and Maintenance Manual, "Steering Frame Lock" for the machine being serviced.Test Procedure
Machine Test
Install a flow meter. Run the engine at high idle. Measure the pump flow at 690 kPa (100 psi) and at 6900 kPa (1000 psi). Use these values in the formula in Table 8.
Table 8
    Pump flow at
690 kPa (100 psi)                    
−     Pump flow at
6900 kPa (1000 psi)     ×     100     =     Percent of flow loss    
    Pump flow at
690 kPa (100 psi)    Bench Test
If the test bench can be run at 6900 kPa (1000 psi) and at full pump rpm, use the formula in Table 8 to determine the percent of flow loss.If the test bench cannot be run at 6900 kPa (1000 psi) or at full pump rpm, run the pump shaft at 1000 rpm. Measure the pump flow at 690 kPa (100 psi) and at 6900 kPa (1000 psi). Use these values in the top portion of the formula in Table 1. For the bottom part of the formula, run the pump shaft at