ROLLER GP-TRACK-DOUBLE FLANGE 9W7827 - Caterpillar

Illustration 1 g00110316
Insert the disconnect switch key into the battery disconnect switch. Turn the battery disconnect switch to the ON position.
Illustration 2 g00115510
Make sure that the reset button for the circuit breaker remains depressed.
Illustration 3 g00107416
Move the hydraulic lockout control to the LOCKED position.This machine is equipped with an engine neutral start system. The system only allows the engine to start when the hydraulic lockout control is in the LOCKED position.
Move the joysticks to the HOLD position.
Turn the grapple/magnet switch to the GRAPPLE position.
Illustration 4 g00103355
(1) Engine start switch (2) Engine speed dial
Turn engine start switch (1) to the ON position.
Illustration 5 g00101408
(3) Coolant level (4) Engine oil level (5) Hydraulic oil level
All of the indicators on the monitor panel should be activated for approximately 1.5 seconds and the action alarm should sound for one second. If any of the indicators are not activated or if the action alarm does not sound, check the electrical system. Make any necessary repairs before you start the engine.If the starter switch is held in the ON position for 2 seconds or more, the prestart monitoring function will be activated. If the fluid level of the engine coolant, the engine oil, or the hydraulic oil is below the specified level, indicator (3), (4), or (5) will come on.If the fluid level is too low, add the corresponding fluid to the specified level. Add the fluid before you start the engine.
Illustration 6 g00103355
(1) Engine start switch (2) Engine speed dial
Turn engine speed dial (2) to the LOW IDLE position.
Turn engine start switch (1) to the START position.
Key must be in run position with engine running to maintain electrical and hydraulic functions and prevent serious machine damage.If the engine does not start, return the key to OFF before returning it to START.Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again.
Release the engine start switch key after the engine starts.The engine of this machine is designed to start without starting aids at temperatures above 0°C (32°F). Starting aids are available for temperatures below 0°C (32°F).
After the engine starts, observe the indicator lamp for the hydraulic tank pressure.
Illustration 7 g00921738
Location of the indicator lamp for the hydraulic tank pressure on right console
When the indicator lamp is no longer illuminated, place the grapple/magnet switch in the MAGNET position.Reference: Refer to Operation and Maintenance Manual, "Grapple and Magnet Control" for further information on the grapple/magnet switch.