ROOF GP-CAB 3899275 - Caterpillar

Illustration 1 g01358455
Advisor display module
Illustration 2 g02382424
The block diagram of the Advisor monitoring system and all other machine control systems."RH OP Station" is included on machines with the serial number prefix A5D, B5E, JWK, or B5P.The Advisor monitoring system monitors the operation of the machine.The Advisor monitoring system provides the operator with the following information about the machine:
Operating characteristics
Diagnostics
Warning events
Modes of operationInstantaneous information and lifetime totals about the condition of the machine and the performance of the machine are constantly gathered by the Advisor monitoring system.The Advisor monitoring system will output information to a display. The display is located on the instrument console. The operator is able to adjust many of the settings in order to match the machine to the desired application. The Advisor monitoring system is also used for the following functions:
Viewing the preferences of the operator
Changing the preferences of the operator
Viewing the parameters of the machine
Changing the parameters of the machine
Illustration 3 g01416825
(1) "Left/Up" arrow button (2) "Right/Down" arrow button (3) "Back" arrow button (4) "Home" button (5) "OK" button for "Enter" or "Select" functionsThe operator provides input to the Advisor monitoring system by use of the buttons that are located on the right side of the display:
"Left/Up" arrow button
"Right/Down" arrow button
"Back" arrow button
"Home" button
"OK" buttonThe Advisor monitoring system allows access to the functions that are listed below:
View a logged event and clear a logged event .
View a diagnostic code or clear a diagnostic code.
View the status of the system components.
View and edit the system parameters.
Calibration of the steering, implements, and power trainNote: Faults that are detected can be cleared by using the Advisor monitoring system. Faults from another ECM may be viewed through the Advisor monitoring system. Faults from another ECM cannot be cleared through the Advisor monitoring system. In order to clear faults from another ECM, see thisService Menu Section - Diagnostics manual.If a warning event occurs, a popup message will appear on the Advisor monitor display. The corresponding action lamp will illuminate on the dash. During a "Level 3" warning, the audio alarm that alerts the operator changes to a pulsing signal. The operator can check the Advisor monitoring system for more specific information.When the engine key start switch is turned on, the Advisor monitoring system continuously monitors all machine systems. The Advisor monitoring system monitors the components that are listed below:
Sensors
Electronic control modules
System components