ROTATING GP-PUMP 1713817 - Caterpillar

Illustration 1 g00298918
Display AreaHarness code mode is mode 1. The machine code is shown on the six digit display area when the main display module is in harness code mode. The machine code must correspond with the monitoring system that is installed on the machine sales model. See the following table for Machine Codes. The machine code is a two-digit representation of the harness code. An incorrect harness code is one that does not match the machine. Incorrect operation of the monitoring system will be caused by an erroneous harness code. Excessive diagnostic codes could be recorded as a result of this situation.
Table 1
Machine Codes    
Sales Model    Machine Code    
515 and 525 (S/N: 1DN375-UP)     60    
525 (S/N: 1DN1-374)     51    
545     58    
814F     54    
815F     57    
816F     58    
824G     47    
825G     48    
826G     49    
938F     02    
938F (Fuel Tank)     04    
950G (Secondary Steering) (1)     07    
950G (Axle Oil Temperature) (2)     13    
950G (Secondary Steering) (3)     15    
950G (4)     38    
950F     39    
960F     40    
962G (Secondary Steering) (1)     08    
962G (Axle Oil Temperature) (2)     14    
962G (Secondary Steering) (3)     16    
962G (4)     41    
966G (Secondary Steering) (3)     18    
966G (Axle Oil Temperature) (2)     20    
966G (4)     42    
966F     43    
970F     45    
972G (Secondary Steering) (3)     19    
972G (Axle Oil Temperature) (2)     21    
972G (4)     44    
980G     46    
980G (Water/Glycol) (5)     50    
IT38F     03    
IT62G     17    
( 1 ) Primary Steering from Power Train ECM and Secondary Steering from switch
( 2 ) Axle Oil Temperature capability and Primary Steering and Secondary Steering from Power Train ECM
( 3 ) Primary Steering and Secondary Steering from Power Train ECM
( 4 ) Primary Steering and Secondary Steering from switches
( 5 ) Special custom applicationsNote: Refer to the following paragraphs for information on the 950G-972G. The Primary Steering and the Secondary Steering are supported by all of the applicable Monitoring System Harness Codes. Some configurations support only direct switch inputs to the Monitoring System, while other configurations may expect information to come from the Power Train Electronic Control Module (ECM).Although the Monitoring System supports Secondary Steering, not all machines have been built with Secondary Steering in place. The appropriate switches may not be installed. The Power Train Control may not respond to the data requests. In order to support for future needs, the Monitoring System modules may be capable of extra functions.