ROTATING GP-PUMP 1964232 - Caterpillar

Using Caterpillar Electronic Technician
The Caterpillar Electronic Technician service tool is used in order to access the calibration procedures. For more information, refer to the manual that was provided with the ET.The calibration menu is used in order to compensate for the differences in the mechanical components and the electrical components. The calibration should be performed if the ECM has been replaced or the ECM was removed. The calibration should be performed if components have been replaced or removed. Perform all calibrations that are applicable.Accessing Calibrations
Connect the ET to the machine. After communication has been established, the ET will list the electronic control modules that are on the machine.
Select the Power Train ECM.
Illustration 1 g01111312
Typical screen for accessing calibrations
Select "Service" from the main menu.
Select "Calibrations" from the drop-down menu. The following is a list of all possible calibrations. The specific calibrations will differ across sales models.
"Transmission Clutch Fill"
"FNR Sensor"
"Brake Touchup"
"Steer Position Sensor"
Select the desired calibration procedure from the fly out window.
Illustration 2 g01111370
Typical screen for performing calibrations
Follow the instructions that are provided on the screen. Note: Additional screens will be displayed in order to notify the operator of the status of the calibration procedure.Using the Advisor
Illustration 3 g01111396
Press the "Home Menu" button.
Press the down arrow until the "Service" line on the menu is highlighted.
Illustration 4 g01125314
Press the "OK" button.
Illustration 5 g01125317
From the "Service" menu, scroll to "Service Password".
Press the "OK" button.
Illustration 6 g01108301
The Advisor will display "Service Mode is Disabled". Press "OK" in order to access the password entry screen.
At the password entry screen, press "OK" in order to enter the password.
Illustration 7 g01125330
Enter the password. Note: Caterpillar sets the last four digits of the machine serial number as the password.
Scroll to the right or left in order to select the desired number.
Press "OK" in order to insert the number.
Repeat steps 8.a and 8.b for the remaining three digits.
Scroll to" Accept" and press "OK".
Illustration 8 g01125333
When the Service Mode is enabled, press the "BACK" button in order to return to the Service Menu. Note: Calibrations will now be a selectable item from the menu.
Illustration 9 g01111644
From the Service Menu, scroll to "Calibrations" and press the "OK" button.
Scroll to the desired system calibration and press the "OK" button.
Blade
Steering
Ripper
Power TrainNote: The following is a list of all possible calibrations. The specific calibrations will differ across sales models.
Scroll to the desired calibration procedure. The calibrations for the Power Train are listed:
"Transmission Clutch Fill"
"FNR Shifter Sensor"
"Left Brake Touch-Up Pressure Cal"
The calibrations for the Steering System are listed:
"Steer Control Position Sensor"
Follow the instructions that are provided on the screen in order to perform the calibration procedure. Brake Touch-up Calibration
In order to adjust the Brake Touch-up Calibration with Cat Electronic Technician, reference "Using Caterpillar Electronic Technician". In order to adjust Brake Touch-up Calibration with Cat Advisor, reference "Using the Advisor".
Make sure that the power train oil is 60 °C (140 °F) or higher.
Select "Left Brake Touch-Up Pressure Cal" from the menu.
Follow the instructions that are provided on the screen in order to perform the calibration procedure.
The current calibration value will be displayed on the