ROTATING GP-PUMP 3264427 - Caterpillar

Illustration 1 g00349720
Note: Before installation, lubricate the bores, the pins, and the lip seals with 5P-0960 Molybdenum Grease .
Lower the temperature of the bearings of the tilt lever. Use Tooling (B) to install the bearing in tilt lever (4). Install the bearing to a depth of 10.0 1.0 mm (0.39 0.04 inch).
Illustration 2 g00349673
Illustration 3 g00349676
Use Tooling (C) in order to install lip seal (9). Make sure that the lip of the seal is facing outward.
Repeat Step 2 for the lip seal on the opposite side of the tilt lever.
Illustration 4 g00349716
Typical Example
Use a suitable hoist and a suitable lifting lifting sling in order to lift tilt lever (4) in position.Note: Aligning the bores of the tilt lever and of the lift arm is important. Improper alignment can damage the lip seals during the installation of the pin.
Illustration 5 g00349725
Typical Example
Carefully install pin (8) .
Illustration 6 g00349652
Install the washer, the spacer, and bolt (7) that holds pin (8) .
Illustration 7 g00349593
Note: Aligning the bores of the tilt lever and of the bucket tilt link is important. Improper alignment can damage the lip seals during the installation of the pin.
Install pin (6) .
Install the washer, the spacer, and bolt (5) that holds pin (6) .
Illustration 8 g00349492
Use a suitable hoist and a suitable lifting sling in order to raise the rod end of the tilt cylinder.
Start the engine. Extend the tilt cylinder.
Align the bore of the tilt cylinder with the pin bore of the tilt lever. Install pin (3) .
Illustration 9 g00349492
Install the washers and bolt (2) in order to secure pin (3) to the tilt lever.
Illustration 10 g00342992
Remove Tooling (A) which is located under bucket tilt link (1) .End By: Install the work tool positioner. Refer to Disassembly and Assembly, "Work Tool Positioner Control - Remove and Install".