ROTATING GP-PUMP 3782842 - Caterpillar

Remove bracket (26) . Remove hose assembly (24) .
Position all the hose assemblies that have been disconnected in Steps 6 through 18 aside.
Illustration 17 g01409970
Attach Tooling (A) , Tooling (B) , and a suitable lifting device to drive shaft (27) . The weight of drive shaft (28) is approximately 114 kg (255 lb). Remove bolts (28) in order to disconnect rear of drive shaft (27) .
Illustration 18 g01410005
Remove cover (29) .
Illustration 19 g01410057
Remove panel (30) .
Illustration 20 g01410059
Disconnect filter assemblies (32) from bracket (31) .
Illustration 21 g01410080
Remove clip (33) . Remove bracket (31) .
Illustration 22 g01409972
Illustration 23 g01409976
Illustration 24 g01410081
Attach Tooling (C) , Tooling (F) , and a suitable lifting device to output transfer gear (34) . Position the lifting slings, as shown. The weight of output transfer gear (34) is approximately 2360 kg (5200 lb). Apply slight lifting tension to output transfer gear (34) . Remove bolts (35) .
Illustration 25 g01410089
Illustration 26 g01481379
Attach Tooling (A) , Tooling (B) , Tooling (D) , Tooling (E) , and a suitable lifting device to output transfer gear (34) .
Illustration 27 g01410096
Illustration 28 g01409993
Remove bolts (36) . Attach Tooling (B) and a suitable lifting device to bracket (37) . The weight of bracket (37) is approximately 45 kg (100 lb). Raise the output transfer gear to the height of 101 mm (4.0 inch). Remove bolts (38) .
Illustration 29 g01481378
Illustration 30 g01481389
Lower output transfer gear (34) in order to attach Tooling (B) , Tooling (C) , Tooling (D) , and a suitable lifting device.
Illustration 31 g01410154
Lower output transfer gear (34) onto a suitable surface. Remove output transfer gear (34) from the rear of the machine.