ROTOR-SENSOR 3427961 - Caterpillar

Secondary ECM Monitoring
Table 5 contains a list of codes that can be generated by the secondary ECM. The secondary ECM provides backup control for the engine. If a problem is detected with the primary ECM, the secondary ECM will provide control for the critical engine components. The table contains the default settings for the applicable codes for your engine. Use Cat ET to view the minimum and maximum ranges for the parameters.
Table 5
Monitoring System Parameters
Event Code Level of Severity Default Delay Time in Seconds Default Trip Point Maximum Engine Derate (%) Default State
E96 High Fuel Pressure (1) 8 1020 kPa (148 psi) N/A Always On
(2) 10 35 Off
(3) 12 N/A
E198 Low Fuel Pressure (1) 10 Pressure drops below 500 kPa (72.5 psi) at engine speeds above 1200 rpm N/A On
(2) Pressure drops below 450 kPa (6. psi) at engine speeds above 1200 rpm 50
(3)(2) N/A N/A Off
E199 Low Coolant Temperature (1) 5 80 °C (176 °F) N/A On
E360 Low Oil Engine Pressure (1) 4 Refer to Illustration 2 N/A Always On
(3)(2) 10 N/A
E361 High Engine Coolant Temperature (1) 5 95 °C (203 °F) N/A Always On
(2) 30 98 °C (208 °F) 100 On
(3)(2) 5 105 °C (221 °F) N/A Always On
E362 Engine Overspeed (1) 0 (1) N/A Always On
(3)(2) (2) N/A On
E539 High Intake Manifold Air Temperature (1) 4 80° C (176° F) N/A Always On
(2) 90 °C (194 °F) 70 On
(3)(2) 100 °C (212 °F) N/A
E1044 High Intake Manifold Pressure (1) 8 500 kPa (73 psi) N/A Always On
(2) Not currently available
(3)
E2112 Low Engine Coolant Pressure (1) 30 Refer to Illustration 3 N/A On
(1) This parameter is set to 115% of the rated speed of the engine for this application. Refer to Cat ET for the rated speed of the engine.
(2) This parameter is set to 118% of the rated speed of the engine for this application. Refer to Cat ET for the rated speed of the engine.
Illustration 2 g02457101
Oil pressure map for the engine monitoring system (reference information)
Illustration 3 g02457737
Coolant block inlet pressure map for the engine monitoring system (reference information)
Illustration 4 g02457736
SCAC coolant pressure map for the engine monitoring system (reference information)
Separate timers are used in the ECM for each response that is associated with a parameter. If a trip point is reached, the timer for that event is started.